21
ADJUSTING THE AIRFLOW DIRECTION
1. Horizontal
The horizontal airflow can be adjusted by moving the vertical vanes with your
hands to the left or right.
When the humidity is high, the vertical vanes should be in the front
position during the cooling or dehumidifying operation. If the vertical
vanes are positioned all of the way to the right or left, condensation may
begin to form around the air vent and drip down.
2. Vertical
The vertical airflow can be adjusted by moving the flap with the remote controller.
Do not move the flap with your hands. Confirm that the remote controller has
been turned on. Use the FLAP button to set either the sweep function or one of
the six airflow direction settings.
•
The flap automatically closes when the unit is off.
•
During the heating operation, the fan speed will be very low and the flap will
be in the horizontal position (position
) until the air being blown out of the
unit begins to warm. Once the air warms up, the flap position and fan speed
change to the settings specified with the remote controller.
•
Use the FLAP button on the remote controller to adjust the position of
the flap. If you move the flap by hand, the flap position according to the
remote controller and the actual flap position may no longer match. If
this should happen, shut off the unit, wait for the flap to close, and then
turn on the unit again; the flap position will now be normal again.
•
Do not have the flap pointed down during cooling operation.
Condensation may begin to form around the air vent and drip down.
CAUTION
A. Sweep function
The flap starts moving up and down to
deliver air over the sweep range.
C. Auto flap function
The flap is set to the recommended
position.
B. Setting the airflow manually
Referring to the above illustration, use the
FLAP button to set the airflow direction
within the range used during the heating,
cooling, or dehumidifying operation.
COOL
DRY
FAN
HEAT
SWEEP
SWEEP
NOTE
CAUTION
