Panasonic CS-KE30NKU, Installation Instructions Manual

14

Indoor
side

Outdoor
side

Hole should be made at a slight downward slant to the
outdoor side.

NOTE

Fig. 10

Plastic cover

INSIDE

OUTSIDE

Wall

Slight
angle

PVC pipe

(Locally purchased)

Fig. 12

PVC pipe (Locally purchased)

Cut at slight angle

Fig. 11

(4) Using a sabre saw, key hole saw or hole-cutting drill

attachment, cut a hole in the wall. See Table 4 and
Fig. 10.

Table 4

(5) Measure the thickness of the wall from the inside

edge to the outside edge and cut PVC pipe at a
slight angle 1/4" (6 mm) shorter than the thickness of
the wall. (Fig. 11)

(6) Place the plastic cover over the end of the pipe (for

indoor side only) and insert the pipe in the wall. (Fig.
12)

3-3.  Install the Rear Panel on the Wall

Be sure to confirm that the wall is strong enough to sus-
pend the unit.

There are a number of screw holes on the rear panel.
Using the 8 screw holes with 

mark is recommended

to attach the rear panel securely to the wall.

See either Item a) or b) below depending on the wall type.

a) If Wooden Wall

(1) Attach the rear panel to the wall with the 8 screws

provided. (Fig. 13)

If you are not able to line up the holes in the rear
panel with the beam locations marked on the wall,
use rawl plugs or toggle bolts to go through the
holes on the panel or drill 3/16" (5 mm) dia. holes in
the panel over the stud locations and then mount the
rear panel.

(2) Double check with a carpenter’s level or tape mea-

sure that the panel is level. This is important to 
install the unit properly. (Fig. 14)

(3) Make sure the panel is flush against the wall. Any

space between the wall and unit will cause noise
and vibration.

b) If Block, Brick, Concrete or Similar Type Wall

Make 3/16" (4.8 mm) dia. holes in the wall. Insert rawl
plugs for appropriate mounting screws. (Fig. 15)

Hole Dia.

3-5/32" (80 mm)

Fig. 13

Fig. 14

3/16"
(4.8 mm) dia. hole

Rawl plug

Fig. 15