Panasonic CS-KS12NB41 Technical & Service Manual Download

Page: 125 / 136

OPERATION WITH THE REMOTE CONTROLLER

1. Automatic Operation

(only for COOL/DRY/HEAT Model)

• Single use

This unit automatically switches between cooling operation and
heating operation according to the difference between the room
temperature and the temperature setting.

• Multiple use

The air conditioner calculates the difference between the
thermostat setting and room temperature, and automatically
determines the mode to operate under cooling or heating. Then,
the air conditioner continuously operates under the mode selected
at initial operation.

2. Manual Operation

Check that the circuit breaker on the power panel is
turned on.

Once

mode is selected and the unit is preset by

following the steps below, you can have the air
conditioner automatically bring the room to the desired
temperature simply by pressing the ON/OFF operation
button.

STEP 1

Press the MODE selector button to

STEP 2

Press the ON/OFF operation button.

To stop the air conditioner, press the ON/OFF operation
button again.

To change the temperature setting; press the
temperature setting buttons and change the setting to
the desired temperature.

STEP 2

STEP 1

NOTE

Check that the circuit breaker on the power panel is
turned on.

If the automatic operation settings of the unit do not
meet your needs, press the setting buttons as
described below and change the settings as desired.

STEP 1

Press the MODE selector button
and select the desired mode.
For heating operation
For dehumidifying operation
For cooling operation
For fan only operation
(No Fan mode in “Multiple use” of
COOL/DRY/HEAT Model)

o
o
o
o

STEP 2

To start the air conditioner, press the ON/
OFF operation button.

STEP 3

Press the TEMP. setting buttons to change
the temperature setting to the desired
temperature.
Adjustable temperature range:
86 °F max.
60 °F min.

STEP 4

Set the FAN SPEED selector button to the
setting you want.

STEP 5

Press the FLAP button and set the airflow
direction as desired.
(Refer to “ADJUSTING THE AIRFLOW
DIRECTION” on page 10.)

To stop the air conditioner, press the ON/OFF
operation button again.

• Choose the best position in the room for the remote

controller, which also acts as the sensor for room
comfort and transmits the operating instructions.
Once you’ve found this best position, always keep the
remote controller there.

• This appliance has a built-in 5-minute time delay

circuit to ensure reliable operation. When the
operation button is pressed, the compressor will start
running within three minutes. In the event of power
failure, the unit will stop.

• The display on the remote controller shows the setting

temperature and not the room temperature.

• When multiple indoor units are used and units in other

rooms are already operating, they will be operating
with the same mode as the operating indoor units.
(only for “Multiple use” of COOL/DRY/HEAT Model)

STEP 2

STEP 3
STEP 1

STEP 4

STEP 5

NOTE