Panasonic CS-KS12NB41 Technical & Service Manual Download

Page: 78 / 136

USING THE REMOTE CONTROLLER

HOW TO INSTALL BATTERIES

Slide the cover in the direction indicated by the arrow and remove
it.

Install two AAA alkaline batteries. Make sure the batteries point in
the direction marked in the battery compartment.

Use a thin object such as the tip of a pen to press the ACL button.

HOW TO USE THE REMOTE CONTROLLER

When using the remote controller, always point the unit’s transmitter
head directly at the air conditioner’s receiver.

REMOTE CONTROLLER INSTALLATION
POSITION

The remote controller may be operated either from a non-fixed
position or from a wall-mounted position. To ensure that the air
conditioner operates correctly, do not install the remote controller in
the following places:

• In direct sunlight
• Behind a curtain or other places where it is covered
• More than 26 ft.(8 m) away from the air conditioner
• In the path of the air conditioner’s airstream
• Where it may become extremely hot or cold
• Where it may be subject to electrical or magnetic noise
• Where there is an obstacle between the remote controller and air

conditioner (since a check signal is sent from the remote controller
every 5 minutes)

MOUNTING THE REMOTE CONTROLLER

Before mounting the remote controller, press the ON/OFF operation
button at the mounting location to make sure that the air conditioner
operates from that location. The indoor unit should make a beeping
sound to indicate that it has received the signal.

To take out the remote controller, pull it forward.

WHEN HOLDING THE REMOTE CONTROLLER

• When using the remote controller and during air conditioner

operation, the transmitter on the remote controller should be
pointed towards the receiver on the indoor unit.

• Make sure that there are no objects between the remote controller

and receiver which could block the signal.

• The batteries last about six months,

depending on how much you use the
remote controller. Replace the
batteries when the remote controller’s
display fails to light, or when the
remote controller cannot be used to
change the air conditioner’s settings.

• Use two fresh leak-proof type-AAA

alkaline batteries.

• In replacing batteries, follow the

instructions as mentioned in the
subsection “HOW TO INSTALL
BATTERIES”.

• If you do not use the remote controller

more than 1 month, take out the
batteries.

• Dispose of the used batteries at the

designated location in compliance
with the applicable local ordinances.

Information for Users on Collection and Disposal
of Old Equipment and used Batteries

[Information on Disposal in other Countries
outside the European Union]

These symbols are only valid in the European Union.
If you wish to discard these items, please contact
your local authorities or dealer and ask for the correct
method of disposal.

Note for the battery symbol (bottom two symbol
examples):

This symbol might be used in combination with a
chemical symbol. In this case it complies with the
requirement set by the Directive for the chemical
involved.

ACL button

CAUTION

Air Conditioner
(Indoor unit)

Receiver

Remote Controller

(Transmitter
head)

• To prevent loss of the remote

controller, you can connect the
remote controller to the holder by
passing a string through the remote
controller and attachment hole.

Remote Control Holder

Mounting Screws

5/32 x 5/8"

(4 x 16 mm)