Panasonic CS-KS12NB41 Technical & Service Manual Download

Page: 82 / 136

USING THE 1-HOUR OFF
TIMER

1. 1-Hour OFF Timer

This function causes the unit to operate for one hour and then
stop, regardless of whether the unit is on or off when this
button is pressed.

The

indicator in the display indicates that this function is

operating.

Setting procedure:

Regardless of whether the unit is operating or stopped, press the 1
HR. TIMER button.

appears in the display.

Cancellation procedure:

Press the ON/OFF operation button to turn the unit off, wait for the
unit to stop operating, and then press the ON/OFF operation button
again.
The 1-Hour Timer function is now cancelled and the unit operates
normally.

• If, while the 1-Hour Timer function is operating, the 1HR. TIMER

button is pressed once to cancel the function and then again, the
unit continues to operate for one hour from that point in time and
then stops.

• It is not possible to use the OFF Timer and 1-Hour OFF Timer

together. Whichever function is set last takes precedence. If the 1
HR. TIMER button is pressed while the TIMER OFF function
operates, the OFF Timer is cancelled and the unit will stop
operating one hour later.

2. Operation together with the daily ON/OFF

repeat timer

The 1-Hour OFF Timer setting is given priority over the DAILY ON/
OFF REPEAT setting.

TIPS FOR ENERGY SAVING

Avoid

• Do not block neither the air intake nor the air outlet. It may

cause less performance, and may leads to malfunctions.

• Do not let direct sunlight into the room. Use sunshades, blinds or

curtains. If the walls and ceiling of the room are warmed by the
sun, it will take longer to cool the room.

• Always try to keep the air filter clean. (Refer to “CARE AND

CLEANING”.) A clogged filter will impair the performance of the
unit.

• To prevent conditioned air from escaping, keep windows, doors and

any other openings closed.

ADJUSTING THE AIRFLOW
DIRECTION

The vertical airflow can be adjusted by moving the flap with the
remote controller. Do not move the flap with your hands. Confirm that
the remote controller has been turned on. Use the FLAP button to
set either the sweep function or one of the six airflow direction
settings.

The flap automatically closes when the unit is off.

• Use the FLAP button on the remote controller to adjust the

position of the flap. If you move the flap by hand, the flap
position according to the remote controller and the actual
flap position may no longer match. If this should happen,
shut off the unit, wait for the flap to close, and then turn on
the unit again; the flap position will now be normal again.

• Do not have the flap pointed down during cooling operation.

Condensation may begin to form around the air vent and drip
down.

NOTE

SWEEP

A. Sweep function

The flap starts moving
up and down to deliver
air over the sweep
range.

B. Setting the airflow manually

Referring to the above
illustration, use the
FLAP button to set the
airflow direction within
the range used during
the cooling or
dehumidifying operation.

C. Auto flap function

The flap is set to
the
recommended
position.

COOL

DRY

FAN

NOTE

CAUTION