Panasonic CS-KS30NKU, Operating Instructions Manual

7

Sensor

A temperature sensor inside the remote controller senses the room 
temperature.

(Cover closed)

CLOCK button

ACL button (ALL CLEAR)

Puts the remote controller into pre-operation status. Always press this button 
after replacing the batteries.

ON/OFF operation button

This button is for turning the air conditioner on and off.

1 HR. TIMER button (1-HOUR OFF TIMER)

:  When you press this button, regardless of whether the unit is operating 

or stopping, the unit operates for one hour and then shuts down.

Temperature setting buttons (TEMP.)

Press the 

 button to increase the set temperature.

Press the 

 button to reduce the set temperature.

The temperature setting changes by 1 °C or 2 °F each time one of the TEMP. 
buttons is pressed.

MODE selector button

Use this button to select DRY, COOL or FAN mode.

(DRY)

: The air conditioner reduces the humidity in the room.

(COOL)

: The air conditioner makes the room cooler.

(FAN)

: The air conditioner works only as a circulation fan.

NIGHT SETBACK button

For details, see “4. Night Setback Mode”. When you press this button in the 
DRY or COOL mode, the 

 mark appears in the display, and the remote 

controller will automatically adjust the set temperature to save energy.

HIGH POWER button

:  If this button is pressed during DRY, COOL or FAN operation, the unit 

operates at maximum output for 30 minutes, regardless of the desired 
temperature.
The fan speed is 1step above ‘‘HIGH’’.

UNOCCUPIED button

For details, see “7. UNOCCUPIED Mode”. When you press this button, the 

mark appears in the display. And the remote controller will automatically 
prevent the room temperature from increasing too much when no one is in the 
room.

• The illustration above pictures the remote controller after the cover has been opened.
• The remote controller sends the temperature signal to the air conditioner regularly at five minute intervals. If the signal from the 

remote controller stops for more than 15 minutes due to the loss of the remote controller or other trouble, the air conditioner will 
switch to the temperature sensor which is built into the indoor unit and control the room temperature. In these cases, the 
temperature around the remote controller may differ from the temperature detected at the air conditioner’s position.

• The indoor fan runs continuously when the system is in normal operation. It does not turn off when the desired room temperature is 

reached. If Night Set Back mode is selected, the fan will turn off intermittently during cooling operation in order to control air flow.

NOTE