- 25 -
Hotel Mode Feature
This models have as a main feature the Hotel Mode, this mode allows to program the receiver with exactly the
same settings than other TV, using a “Clone Box”. (Only models with Digital interface).
Clone Box Use
The clone box uploads (LEARN) the settings
of one television and downloads (TEACH)
them to other televisions. This places the
television into Commercial (Hotel) Mode.
Note:
The Clone Box is not supplied with the set. It
can be purchased separately.
Setting the “Master” Television
The features listed in the Commercial (Hotel)
Mode table must be adjusted before cloning
can begin.
1. Turn the television ON.
2. Access the Main Menu by pressing the
ACTION button.
3. Access the Set Up menu.
•
Use the CH and VOL buttons to highlight
the Set Up icon, then press the ACTION
button.
•
Use the CH buttons to highlight AUTO
PROG (Auto Channel Programming),
then press the VOL button to begin
programming.
Note:
This step is mandatory.
•
If necessary, use MANUAL PROG
(Manual Channel Programming) to delete
any undesired channels.
•
Press the ACTION button to return to the
Main Menu.
4. If necessary, access the Picture menu.
•
Use the CH and VOL buttons to highlight
the Picture icon, then press the ACTION
button.
•
Use the CH buttons to highlight a feature,
then press the VOL buttons to adjust
them.
•
Press the ACTION button to return to the
Main Menu.
5. If desired, access the Channel Caption
menu.
•
Use the CH and VOL buttons to highlight
the Ch Cap icon, then press the ACTION
button.
•
Use the CH buttons to highlight the
channel number, then press the VOL
buttons to select characters for the
channel caption.
•
Press the ACTION button to return to the
Main Menu.
6. Exit the Main Menu by pressing the
ACTION button.
7. If necessary, set the maximum volume
level.
8. If the hotel has hotel “barker” channel,
tune the set to the “barker” channel.
IMPORTANT
When the set is in Stand-Alone (SA) hotel mode,
(No digital interface conneted to TV) The menu
screen can only be accessed using the ACTION
button on the Panasonic remote control.
When the set is in Slave-to-Mate (STM), hotel
mode (Using the digital interface) the menu
screen can be accessed only using the Hotel
remote control.
Uploading Television Settings into
the Clone Box (LEARN)
1. Press the POWER ON button on the
clone box.
•
The LEDs will flash red and green to
confirm power is ON.
2. Connect the clone box to the Digital
Interface port on the back of the
television.
•
The television must be plugged into an
AC outlet but can be either OFF or ON.
3. Hold the ALT button while pressing the
LEARN button.
•
The red LED will flash while the data is
uploaded to the box. The green LED will
light for about two (2) seconds when the
procedure is complete.
Note:
The television is now in Commercial
(Hotel) Mode.
4. Disconnect the clone box from the
television and turn it OFF.
Note:
This will not affect the data stored in
the box as long as the battery is
inserted and charged.
Model CT-2511HD
Model CT-2511HD does not have a digital
interface on the back of the television. To set
the television, use the front panel.
