- 26 -
Downloading Settings into Other
Televisions (TEACH)
1. Press the POWER ON button on the
clone box.
•
The LEDs will flash red and green to
confirm power is ON.
2. Connect the clone box to the Digital
Interface port on the back of the
television.
•
The television must be plugged into an
AC outlet but can be either OFF or ON.
3. Press the TEACH button.
•
The green LED will flash while data is
downloaded to the television. The green
LED will light for about two (2) seconds
when the procedure is complete.
Note:
The television is now in Commercial
(Hotel) Mode.
4. Disconnect the clone box from the
television and turn it OFF.
5. Repeat steps 1 – 4 to set up other
televisions.
Setting Individual Volume Limits
This procedure allows the maximum volume
level to be changed on individual televisions.
For lower volume
The television must be in Commercial (Hotel)
mode.
1. Turn television ON.
2. Adjust the television volume to desired
level.
Note:
This will become the new maximum
volume level.
3. Press the POWER ON button on the
clone box.
•
The LEDs will flash red and green to
confirm power is ON.
4. Connect the clone box to the Digital
Interface port on the back of the
television.
5. Hold the ALT button while pressing the
LEARN button on the clone box.
•
The red LED will flash while the data is
uploaded into the box. The green LED will
light for about two (2) seconds when the
procedure is complete.
6. Disconnect the clone box from the
television and turn it OFF.
7. Reset the volume on the television.
8. Refer to the section entitled Setting Up
Other Televisions Using the Clone Box
(TEACH)
For higher volume
The television must be in Normal TV mode.
Refer to the section entitled Resetting the
Television to Normal TV mode.
1. Turn television ON.
2. Adjust the television volume to the
minimum setting.
3. Press the POWER ON button on the
clone box.
•
The LEDs will flash red and green to
confirm power is ON.
4. Connect the clone box to the Digital
Interface port on the back of the
television.
5. Adjust the television volume to
maximum desired level.
6. Hold the ALT button while pressing the
LEARN button on the clone box.
•
The red LED will flash while the data is
uploaded into the box. The green LED will
light for about two (2) seconds when the
procedure is complete.
•
If the green LED does not light for about
two (2) seconds, retry by holding the ALT
button while pressing the LEARN button.
7. Disconnect the clone box from the
television and turn it OFF.
8. Reset the volume on the television.
9. Refer to the section entitled Setting Up
Other Televisions Using the Clone Box
(TEACH).
IMPORTANT
When the set is in Stand-Alone (SA) hotel
mode, (No digital interface conneted to TV)
The menu screen can only be accessed using
the ACTION button on the Panasonic remote
control.
When the set is in Slave-to-Mate (STM), hotel
mode (Using the digital interface) the menu
screen can be accessed only using the Hotel
remote control.
