11
6
E
N
G
L
I
S
H
CX-DP880U
10
5
E
N
G
L
I
S
H
CX-DP880U
Error Display Messages
Trouble Shooting Tips
Trouble Shooting Tips
(continued)
¡
Numbers before E1, E2 are error disc numbers.
¡
Display messages differ depending on the control unit.
Reset Switch
Press the
reset switch
with a sturdy and pointed object when
any operations do not function. If the unit does not become
restored even after pressing the reset switch, contact your
nearest Panasonic Service Center for service.
If the Unit Begins to Operate Malfunctionally...
Troubleshooting
Preliminary Steps
Check and take steps as described in the tables below.
If You Suspect Something Wrong
Immediately switch power off.
Disconnect the power cable and check that there is neither smoke
nor heat from the unit before asking for repairs. Never try to repair
the unit yourself because it is dangerous to do so.
Cautions:
¡
Do not use the unit if it malfunctions or
something is wrong.
¡
Do not use the unit in an irregular condition,
for example, no sound, smoke or foul smell,
which can cause ignition or electric shock.
Immediately stop using the unit and call the
store where you purchased it.
No sound is heard
when inserting a CD
magazine containing a
compact disc.
Music sounds skip due
to vibration.
Sounds skip occasion-
ally.
The CD magazine is
not ejected.
No sound is
reproduced, even if
the CD changer mode
is active on the
control unit.
Disc is upside down.
a
Place disc in the correct direction with the label side up.
Disc is dirty.
a
Clean disc, referring to the section on “Notes on Discs (CD, CD-R,
CD-RW, CD-ROM)” (
a
Page 16).
Cords are not correctly connected.
a
Connect the cords crrectly.
The CD magazine is not correctly inserted.
a
Refer to “Loading and Removing the Magazine” for details.
(
a
Page 9)
The power switch on the control unit is not turned ON.
a
Turn on the power switch on the control unit.
A disc that has data other than CD-DA (ex. MP3, WMA) is loaded.
a
Discs that have CD-DA data should be used.
a
Some CD-R/RWs can not be played back successfully thanks to
incompatibility among writing software, a CD recorder (CD-R/RW drive)
and the discs. Refer to instructions for the concerned devices for
details.
The mounting screws are tightened in the wrong directions.
a
Set the mark “V” or “H” of the angle adjust screws to the correct mount-
ing direction.
a
Some CD-R/RWs can not be played back successfully thanks to
incompatibility among writing software, a CD recorder (CD-R/RW drive)
and the discs. Refer to instructions for the concerned devices for
details.
Disc is dirty.
a
Clean disc, referring to the section on “Notes on Discs (CD, CD-R,
CD-RW, CD-ROM)” (
a
Page 16).
The CD magazine is defective.
a
Press the reset switch.
Contact the shop from which you purchased it or your nearest Panasonic
Service Center.
The CD changer is not correctly mounted.
a
Securely fix the main body with a location almost free from vibration.
The CD magazine is not correctly inserted.
a
Attempt to insert the CD magazine correctly.
Trouble
Cause/Step
Trouble
Cause/Step
Displays when the compact disc is dirty or when it is inverted.
Next compact disc is automatically selected.
Displays when the compact disc has a scratch on it.
Next compact disc is automatically selected.
Displays when the unit stops operating for some reason.
Press the eject button of changer unit.
Displays when there is no disc in the disc magazine.
Display
Possible Cause/Possible solution
