ー
97
ー
Operating Instructions
Intelligent Controller
102
Settings for energy saving
Energy saving
9
Set the times.
z
The time on the left is the control start time.
The time on
the right is the control end time.
z
Use
to set the time. Hours can be set in the
range
0 to 23, and minutes may be either “00” or “30”.
9
10
Touch [Register].
z
The “T
erm setting” dialogue closes.
z
To cancel the settings, touch [Cancel].
10
11
Put a check mark in the “V
alid” column.
11
Continued on next page
Item
Explanation
O/D unit cyclic Valid
The O/D unit cyclic function is enabled for the selected outdoor unit if you put a check mark here.
5
Touch [Register].
z
The “Setting” dialogue closes.
z
To cancel the settings, touch [Cancel].
5
6
Set other indoor units.
z
Repeat steps
3 to 5.
7
Touch [T
imer set.].
z
The “T
erm setting” dialogue is displayed.
7
8
Touch the number
.
z
You can set 4
dif
ferent time slots.
8
Control operation at regular intervals [O/D unit cyclic]
103
Settings for energy saving
Energy saving
12
Select “Y
es” for “O/D unit cyclic”.
12
13
Touch [Register].
z
To cancel the settings, touch [Cancel].
13
Note
y
Up to 5
control groups can be created.
y
Control groups that have not been set will not be the object of cyclic control.
The “O/D unit cyclic” screen
A:
[Select all]/[Clear all] buttons
[Select all]
Select all outdoor units.
[Clear all]
Cancel selection of all outdoor units.
B:
Set whether to enable outdoor unit cycling control across the whole system or not.
Note
y
If you select “Y
es”, make sure that you set
“No” for indoor unit cycling control settings.
C:
Change
list order
. The list order
changes
each
time you touch it.
Display
The display follows the order set in “I/D unit settings” (P
.141).
O/D unit
The display follows the address order of the outdoor unit systems.
Address
The display follows the address order set in “I/D unit settings” (P
.141).
D:
The outdoor units with a check mark next to them will be the subject of the changes to the settings.
E:
The O/D unit cyclic is enabled for the selected outdoor unit if you put a check mark here.
This is linked with the “O/D unit cyclic
Valid” (“Setting” dialogue) (P
.102) setting.
F:
The “T
erm setting” dialogue is displayed when you touch this.
G:
The “Setting” dialogue is displayed when you touch this.
A
C
B
E
G
F
D
Control operation at regular intervals [O/D unit cyclic]
TGR-318_ENG.indb 97
2017/04/06 10:43:39
