15
9. USING THE REMOTE CONTROLLER
• Point the transmitter of the remote controller at the receiver. When the signal is received correctly it
will beep once. (It beeps twice only when the unit starts operating.)
• The signal can be received at a distance of about 19 ft. This distance should be used only as a
guide. It depends on battery strength.
• Make sure nothing is between the remote controller and the receiver that could block the signal.
• Do not leave the remote controller in direct sunlight, where the wind from the air conditioner can
blow directly on it, or near any other heat source.
• Take care not to drop, throw or wash the remote controller with water.
• The signal from the remote controller may not be received in rooms with rapid start fl uorescent
lighting, inverter lights, plasma displays, LCD televisions (monitor), etc. For more information, please
contact the dealer where the product was purchased.
Wall Mount Use
• Press from the location you wish to mount the remote
controller and make sure the signal is received correctly.
• Pull the remote controller forward to remove it.
10. FOR BEST RESULTS
Don’t get the remote controller too far away from the receiver.
This may cause a malfunction.
Be sure to keep the remote controller in the same room as the receiver.
Point the remote controller at the receiver.
When the signal is received correctly it will beep one time.
Avoid locating the remote controller where it is covered, such as behind a curtain.
Keep it out in the open.
1
2
Fasten the Remote
Controller mount
with screws.
Fitting the Remote
Controller in the
mount.
Remote Controller
mount
Press
Put in
Instruction̲eng.indd 15
Instruction̲eng.indd 15
2012/01/27 16:25:34
2012/01/27 16:25:34
