8
(EN)
Installing Wireless Remote Controller
Installation location for the Wireless Remote Controller
If a remote controller is to be operated from a remote control holder that is hung on a wall, turn
on the lights in the room as well as any electrical appliances and then check to make sure the air
conditioner works with the remote controller in the location where it will be installed. If it works,
continue with installation.
If the main sensor is to be switched from the indoor unit to a remote controller, pay attention to the
following when installing.
• Locate where no warm or cold air will affect it.
• Locate in a place free from direct sunlight.
• Locate where it will not be affected by any other heat/cold source.
When installing the remote controller onto a wall, etc.
Screw the remote control
holder.
Remote control holder
Installing the remote
controller
2
Press
1
Insert
Press
at the installation location
on the wall, and check that normal
receiving is possible.
Remove the remote controller from the
remote control holder.
Test Operation
Preparation:
Turn on the circuit breaker of units and then turn the power on. After the power is turned
on, remote controller operation is ignored for approx. 1 minute because setting is being
made. This is not malfunction. (Contents received while setting are disabled.)
1. To start test operation, press and hold the emergency operation button for 10 seconds.
2. The indication lamps (OPERATION, TIMER, STANDBY) blink during test operation.
3. To
fi
nish test operation, press and hold the emergency operation button for 10 seconds.
Attention
Do not use this mode for purposes other than the test operation.
(To prevent overload of the units)
Read the installation instructions supplied with the units.
Any of the Heat, Cool and Fan operations can only be performed.
Temperature cannot be changed.
The test operation mode is automatically turned off in 60 minutes.
(To prevent continuous test operation)
Outdoor units do not operate for approx. 3 minutes after the power is turned on or operation is
stopped.
Settings
Summary of Contents for CZ-RWSU3
Page 10: ... Panasonic Corporation 2016 ...
