Section 400-Programming
Chapter 3. Extension Programming (FF3)
DBS-2.3/9.2-400
DBS Manual - Revised April 2000
Page 3-11
Offhook Signal (CO)
Software Version: All Versions
Address: FF3 (ExtPort)# 7# (0 or 1)#
Description
This program determines if the DBS sends a tone signal to busy extensions
when an additional trunk call arrives.
Programming
To activate the Offhook Signal ...
To reset the Offhook Signal to the default value ...
Related Programming
Offhook Signal Volume: FF3 (ExtPort)# 15# (0-4)#
Offhook Signal Pattern: FF3 (ExtPort)# 16# (0 or 1)#
Notes
Conditions Under Which the Signal Is Not Sent.
The system will not send
the Offhook Signal (even if enabled) during a conference call, while the
called extension is on hold, or during a call on a trunk that does not have a
dedicated line key on the phone.
Station Hunting Interaction.
If an extension is enabled for Offhook
Signaling, the extension will be excluded from any hunt group setting that
may be enabled for it.
VAU Interaction.
If a Voice Announce Unit (VAU) is connected to the
DBS, disable Offhook Signaling (CO) to prevent VAU calls from being
interrupted by incoming trunk calls.
FF3 (1-144)# 7# (0 or 1)#
Extension Port
0=Disable Offhook Signaling.
1=Enable Offhook Signaling.
Note:
Default for the Primary
Attendant is
1
(“Enable”)
.
FF3 (1-144)# 7# CONF ON/OFF
Summary of Contents for DBS-2.3-400
