Chapter 3. Extension Programming (FF3)
Section 400-Programming
Page 3-58
DBS Manual - Revised April 2000
DBS-2.3/9.2-400
Auto-Redial on Extensions
Software Version: CPC-AII and CPC-B, Version 7.0 or higher
Address: FF3 (ExtPort)# 49# (0 or 1)#
Description
Use this address to enable or disable the Auto-Redial feature on individual
DBS extensions (DSLT or K-Tel only). Auto-Redial allows a telephone in
the on-hook (idle) state to redial an internal extension or an outgoing trunk
call without going off-hook first. By default, Auto-Redial is enabled on all
DSLT and K-Tel extensions.
Auto-Redial is performed by pressing REDIAL when the phone is either on-
hook (idle) or off-hook (dial tone). The DBS will automatically redial the last
number dialed on that extension.
Programming
Notes
Restrictions.
Auto-Redial will not work with the following:
•
SLTs
•
OPX
•
API
•
Voice Mail
•
Door Phones.
Auto-Redial After a System Reset.
If Auto-Redial is attempted after a
system reset, and neither a CO call nor an extension call has been made since
the reset, the caller will hear intercom busy tone.
FF3 (1-144)# 49# (0 or 1)#
Extension Port
0=Auto-Redial is disabled.
1=Auto-Redial is enabled.
Summary of Contents for DBS-2.3-400
