Chapter 7. Toll Restriction (FF7)
Section 400-Programming
Page 7-12
DBS Manual - Revised April 2000
DBS-2.3/9.2-400
International Calling on Extensions
Software Version: CPC-A Version 4.0 or higher; CPC-AII/B Version 6.0 or higher
Address: FF7 1# 19# (ExtPort)# (0 or 1)#
Description
This address applies only to systems programmed to use the new NANP
dialing plan (FF7 1# 17# 1#). Also, this switch applies only to TRS types 3-6
(TRS types 0-2 do not allow international dialing; TRS type 7 allows all
dialing).
Use this address to allow or deny international calling on individual
extension(s) that are “exceptions to the rule”.
• When an extension attempts an overseas call (trunk 01 or 011) on
a trunk assigned TRS type 3-6, the system checks the setting in this address
(default=deny call).
• However, if this address is set to “1”, the system checks the “International
Calling For TRS Types 3-6” (FF7 1# 1#) to see if the dialed country code
should be checked against the Country Code Table (FF7 1# 20#) before
allowing the call. If so, and if the dialed country code is included in the
table, the call is allowed.
Programming
Related Programming
International Calling For TRS Types 3-6: FF7 1# 1# (0 or 1)#
Dialing Plan Switch: FF7 1# 17# (0 or 1)#
Country Code Table: FF7 1# 20# (Table)# (Code)#
FF7 1# 19# (1-144)# (0 or 1)#
Extension Port
0=Deny call.
1=Check the International
Calls Switch (FF7 1# 1#)
Summary of Contents for DBS-2.3-400
