Section 700 - Operation
Chapter 7. SLT Features
576-50-700
DBS 576HD (USA) issued September 2001
6-27
To answer a Camp-on (Call Waiting) signal:
Hardware Requirements
•
N/A
Related Programming
•
FF1-0-03: Extension COS (Manual Camp-on Send)
•
FF1-0-03: Extension COS (Manual Camp-on Receive)
•
FF1-2: Dial Plan
•
FF3: Extension COS
•
FF3-0: Auto Camp-on
Considerations
•
You can transfer an outside call to a busy extension using Camp-on. See “Camping a Call Onto a
Busy Extension” on page 6-25.
Conference Calls
Description
Conference Calls allow you to add another party to an existing conversation. With the standard
system configuration,
up to 4
parties can be included in a conference call at any one time. If the
optional Conference Card is installed, additional parties up to a total of 8 can participate in a
conference call.
Any combination of extensions and CO lines can be in the conference as long as the original
extension is in the conference and the total number of parties does not exceed 8. Only one operation is
used to establish and add to a conference. You simply have to place the current call on hold, dial the
next party and press the
CONF
key. No different operation or access code is required to add
additional parties to the call.
When no optional conference card is installed, the system supports the following types of
four
-party
conference calls:
•
4
extensions
•
3
extensions and 1 CO line
•
2
extension and 2 CO lines
•
1 extension and 3 CO lines
Action
Result
1. Replace the handset or press the
ON/OFF
key.
2. Lift the handset or press the
ON/OFF
key again to be con-
nected to the waiting call.
OR....
Press the
HOLD
key.
• Current call placed on hold
• Connected to waiting call
