Smooth Operator Configuration Note (77200)
Panasonic DBS
C o n f i d e n t i a l
P a g e
1 1
The above information is provided by Octel Communications Corporation as a guide.
See disclaimer on page 1
O c t e l C o m m u n i c a t i o n s
Outside Line Access Code
9,
Off Hook Delay (OFFHDLY)
25
Hook Flash Interval (FLINTVL)
50
DTMF Tone Length (TONELEN)
8
Transfer, Paging and Screening Parameters
Custom Transfer Code
&,XDR
Call Waiting Code
3
Intercom Paging Code
&,C3#00N
Transfer Release Code when Busy
&
Transfer Release Code when No Answer
&
Release Code for Call Waiting
-
(hang up)
Call Screening Release Code when Busy
&
Call Screening Release Code when No Answer
&
Call Screening Release Code when Reject
&
Call Screening Release Code When Transfer
&,&
Release Code for Intercom Paging
&
Message Waiting Parameters
Permit Message Waiting Lights
Enabled
Message Waiting Light Prefix On
,*4
Message Waiting Light Prefix Off
,*5
Inband Parameters
Total Number of DID Digits
4
DID Terminating Character
(None)
Seconds to Wait for First Digit
1
Location of Inband Signaling Code
1
Millisecs to Wait for Next Digit
750
Code for Immediate Subscriber Login to Mailbox
*
Start at End of String for Immediate Login
Disabled
Location of Mailbox Number for Immediate Login
2
Start at End of String for Default Code
Disabled
Location of Mailbox Number for Default Code
1
Note: Verify these dialing sequences for your PBX.
In addition to running the Integrator, ensure the following parameters are
set to their corresponding values in System Setup:
Hang-up Detection
Dial Tone Detection Time (DTONDET)
500
Minimum Duration for Drop in Loop Current (LCDTIME)
15
Outbound Calls Parameters
Time to Wait for Possible Incoming Call (SCHDWAIT)
0
(See paragraph 7.3)