8. When using this Shower Head, select the preferred shower with the Shower Select Button.
Please press the button fully.
Push
Shower
Head
Shower
Select
Button
Push
Press
Note:
When stopping the water flow or change water
shower selection from Wide Shower to Spot
Shower, some water will continue to drip from
Shower Head or Rain Shower Head for less than
2 minutes. This is normal due to some water remain
in the Shower Head and Rain Shower Head, this is
no abnormality to the Unit.
Do not block the Shower Head and Rain Shower Head with hand,
towel or bend the hose. The water flow rate will drop and
water temperature may become very hot.
CAUTION
Push
HOW TO USE ELECTRIC HOME SHOWER
1. HOW TO USE
6. Temperature setting
(a) The shower temperature can be gradually controlled by setting the Power Control Knob to the
desired position.
(b) If you turn the Power Control Knob clockwise the shower temperature will go up, reaching the
highest temperature at “High”.
The temperature can be gradually controlled.
(c) If the Power Control Knob is at “Off” position, the water temperature will remain at inlet temperature.
(d) In case of continuous usage at high temperature setting, water temperature will increase and
it may cause the control device in the set to activate temporarily resulting water temperature to drop.
1. Turn “On” the Main Water Valve.
2. Switch “ON” the Miniature Circuit Breaker (MCB) and ON/OFF DP (double pole) Switch.
3. Push the ELB Reset Lever if it is down.
4. Turn Water Volume Knob to clockwise.
• Turning it clockwise increases the volume of water thus decrease the water temperature.
• Turning it anticlockwise decreases the volume of water thus increase the water temperature.
5. Press the Push On-Off Lever, water will start flowing from the Shower Head and the ELB light
will turn red.
• To stop the water flow, press the Push On-Off Lever again (the position of the Push On-Off
Lever remains the same).
• This button controls both water and electricity supply to the set.
• Adjust to the desired shower condition by operating the Water Volume Knob and the Power
Control Knob.
Then the operation can be made easily by pushing the Push On-Off Lever only.
Press Push On-Off Lever before and after each
shower.
Press the Push On-Off Lever only. Do not pull.
Do not turn "On" and "Off" the Main Water
Valve to operate the shower Unit to avoid any
possible damage.
For DH-3NP2 model only
To ensure Pump reliability, Push On-Off Lever
must be pressed before and after each shower.
Do not pull the Push On-Off Button, press only.
CAUTION
Powe
r Control
Off
High
ELB
ELB Test
ELB Reset
Push Up
DH-3NS1
Push On-Off
Powe
r Control
Off
High
ELB
ELB Test
ELB Reset
Push Up
DH-3NS1
Push On-Off
Powe
r Control
Off
High
ELB
ELB Test
ELB Reset
Push Up
DH-3NS1
Push On-Off
Power Control Knob
ELB Lamp
ELB: ON condition
ELB: OFF condition
Make sure push at the
center of Push On-Off
Lever only.
7. Water flows will gradually change from Rain Shower Head to Shower
Head by turning the Diverter anticlockwise.
Note:
Water volume will decrease if the water flows simultaneously at the
Shower Head and Rain Shower Head.
ush
ush
ENGLISH
OPERA
TION
- 21 -
