9. Shower Head can be set at various positions.
For DH-3NS1, DH-3NS2, DH-3NP2
(a) Loosen Shower Hanger Knob and Shower Hanger can be adjusted
higher or lower position.
Tighten Shower Hanger Knob.
(b) Loosen Shower Hanger Knob and Shower Hanger can be
adjusted to the left or right position. Tighten Shower Hanger Knob.
(c) The angle of Shower Head can be adjusted by moving the
Shower Head upward or downward.
Push
Push
Push
Shower Hanger
Shower Hanger
Knob
(a)
(b)
(c)
For DH-3NP2 model (with Rain Shower) only
10.
Shower Head can be set at various positions:
(a) Push and hold the Shower Hanger Button
to adjust higher or lower and left or right.
Release the Shower Hanger Button to fix
position.
(b) The angle of Shower Head can be adjusted
by moving the Shower Head upward or downward.
11. Rain Shower can be set at various positions:
(a) Loosen the Adjustable Lock and adjust the Upper Shower Pipe higher or lower and
left or right. Tighten the Adjustable Lock.
When setting the Upper Shower Pipe at maximum height, lower down the pipe a bit
if feel a jerk followed by tightening the Adjustable Lock (this is to avoid leaking due to
exceed the maximum height setting).
(b) The angle of Rain Shower Head can be adjusted by moving the Rain Shower Head
upward or downward.
Note:
When turning OFF the Home Shower, remaining water from the Shower Head/ Rain Shower Head
may continue to drip before it stop completely.
ELB Test
ELB Reset
Push Up
Push On-Off
Powe
r Control
Off
High
ELB
Push
11 (b)
11 (a)
10 (b)
10 (a)
(1) How to adjust to maximum water flow rate.
Step 1:
Push the Push On-Off Lever and select Wide Shower type on the Shower Head using the Shower Select Button
(refer Figure 1).
Step 2:
Turn “Off” the Main Water Valve.
Step 3:
Turn the Shower Head upward at waist height.
Step 4:
Turn the Water Volume Knob to maximum volume position (refer Figure 2).
Step 5:
Gradually “On” the Main Water Valve and adjust the splashing height (H) of the shower.
It is recomended to adjust the water splashing height (H) at 100 cm ~ 110 cm (approximately 3 L/min).
(If splashing height (H) is too high, hot water temperature will drop because of an excessive flow rate).
2. WATER FLOW RATE ADJUSTMENT
Note: 1. Pay attention to shower temperature when reducing the volume of water.
The shower temperature will become very hot if the water flow rate is too low.
2. Water Volume Knob is at maximum position at this stage (refer Step 4).
Please adjust it to suitable flow rate using the Water Volume Knob by turning it anticlockwise.
Pow
er Control
Off
High
ELB
ELB Test
ELB Reset
Push Up
DH-3NS1
Push On-Off
Spot Shower
Normal Shower
Wide Shower
Figure 1
Figure 2
Shower Select Button
H = 100 cm ~ 110 cm
Waist Height
Floor
Water Volume Knob
Main Water
Valve
Push On-Off Lever
Water Volume Knob
CLEANING
FILTER
Push
Press
For DH-3NP2 (with Rain Shower), make sure the water flow at the Shower Head only.
If water flow rate is too low, possibility of water flow from the Rain Shower is not enough.
Please consult with authorized sales personnel for assistance.
- 22 -
