7.
Make sure the wall level must be same to the Rail
Holder fixing position. If the wall is not at the same
level, please use spacer (not included) to fix the
accessory.
②
Install the Upper Rail Holder on the wall but
not higher than the Unit top.
Tighten the Upper Rail Holder with 1 screw .
③
Prepare the Shower Hanger and Sliding Rail,
remove the Shower Hanger Knob by rotating
it (anticlockwise) then install the parts
following the number (1), (2) and (3).
⑦
Adjust the Shower Hanger at the
required level and hang the
Shower Head as shown in
diagram below.
④
Tighten the Shower Hanger with
Shower Hanger Knob.
* Shower Hanger will drop off easily
once the knob is loosen.
Sliding Rail
Shower Hanger Knob
Hole to fix
Shower Head
Top
Bottom
Shower Hanger
⑤
Install to the Upper and Lower
Rail Holder with the Grooves of
the Sliding Rail inserted to the
Rail Holder's Notches.
Tighten the Lower Rail Holder
with 1 Screw (Make sure to
insert the Wall Plugs into the
screw hole).
⑥
Cover the Upper and Lower Rail
Holder with the Rail Holder
Covers
Tighten the Screw if
Shower Head moves
downward.
①
Install the Rail Holder so that the Shower
Head height not higher than the unit top.
Shower Hanger
Knob
Sliding Rail
(1)
(3)
(2)
Shower Hanger
Upper Rail Holder
Shower Head
Lower Rail Holder
ELB Test
ELB Reset
Push Up
Push On-Off
Push
Hot
Health
Safe
Bubble
o
C
Beat
Level
Normal
Cool
e-Cycle
Set
Max
PM
e-Hybrid
+
-
Screw
Upper Rail Holder
Screw
Sliding Rail
Groove
Notch
Upper Rail Holder
Cover
Lower Rail Holder
Cover
Push
Shower Head
Shower Hanger
Tighten the Upper Bracket with 1 screw.
(Make sure to insert the Wall Plugs
through the screw holes.)
8. Rain Shower Installation
[DH-3NP2 (with Rain Shower)]
Approximately
30 mm
36.5 mm
5 mm
Install the Upper Bracket on the wall at the
same height or lower than the Unit top.
Install the Lower Bracket by tighten Lower
Bracket with screws as shown in Figure 1
(make sure to insert the Wall
Plugs through the screw holes).
Lower Bracket position must be
inline with Upper Bracket. The
distance between the Upper Bracket
and Lower Bracket as shown in Figure 2.
7. Shower Hanger Installation
Cover the Lower Bracket with the Lower Bracket Cover.
Note: Please make sure the Rubber Packing is set at the Lower Bracket Cover
to avoid any damage to the part.
Rubber Packing
Lower Bracket Cover
Lower Bracket
Approximately
743 mm
Figure 2
ELB Test
ELB Reset
Push Up
Push On-Off
Powe
r Co
ntrol
Off
High
ELB
Assemble the Rain Shower Hanger to Lower Shower Pipe by push and hold the
Hanger Button.
Release the Hanger Button to fix at desired position.
①
②
③
④
Figure 1
①
②
③
④
- 28 -
