PICTURE
SOUND
REMOTE CONTROL
DISPLAY
8
61
Page
Software Update
53
No picture.
î
Check the connection to the TV, e.g. AV1.
î
The PROGRESSIVE output is activated, but the connected TV is not
progressive-capable.
!
Press and hold
STOP
and
on the unit at the same time for more than
5 seconds. The function is switched to half-picture (INTERLACE).
PLAY/x1.3
There is picture interference.
î
The [TV System] setting does not match that on the disc.
!
In
STOP
mode, press and hold
STOP
and
OPEN/CLOSE
on the unit for more
than 5 seconds. This switches the unit from PAL to NTSC or vice versa.
61
50
Television reception worsens
when the unit is connected.
î
You may need to use a signal amplifier.
Check the antenna connection and the alignment of your antenna.
The TV picture format is not
set correctly.
î
Check the [TV Aspect] setting in the [Connection] [Setup] menu.
50
No On-screen messages.
î
Change the [On-Screen Messages] setting in the [Display] [Setup] menu.
49
45
Poor picture in spite
of good signal quality.
î
Overmodulation makes the signal strength display go to red.
!
Readjust the picture with your room aerial until the picture quality improves.
No sound. Distorted sound.
Volume set to quiet.
î
Check the connections.
î
If you connected an amplifier, check the input mode.
î
Switch off the V.S.S. function if it causes problems.
It is not possible to hear the
desired sound type.
!
Press
DISPLAY
to select the desired sound type.
!
Change the appropriate setting in the Sound Setup menu.
The sound cannot be set for
stereo or NICAM broadcasts.
î
Connect external unit with audio cables even if you use a digital connection.
î
You can change the sound type when using DVD-RAM.
î
The sound cannot be switched on some discs.
8
57
57
63
No functions.
î
An incorrect remote control code was selected.
î
Check the batteries.
î
Point the remote control at the sensor on the unit.
î
The child lock feature has been activated.
The TV cannot be operated.
î
An incorrect remote control code was selected.
65
65
65
5
65
î
No time. Set the time in the [Others] [Clock] [Setup] menu.
The display light is weak.
î
Change the [FL Display] setting in the [Display] [Setup] menu.
"0:00" blinks on the unit display.
49
52
Video or audio is not recorded
from an external unit.
î
The external unit is not connected correctly.
î
The incorrect input channel AV2, AV3, AV4 or DV IN was selected.
63
63
External Input
When are the software updates
broadcast?
î
The unit shows automatically when a software update has been broadcast, and
also automatically updates the software if thus function has not been switched off
in the [Setup] menu.
74
Informations
If you need help