Troubleshooting
VQT4L30
93
The following messages or service numbers
appear on the unit’s display when something
unusual is detected.
The remote control and main unit are using
different codes. Change the code on the remote
control. (
>
87)
Selected titles in the USB HDD are being
converted.
Do not disconnect the USB HDD from this unit.
TV Guide data is being downloaded.
If there is no change after switching the unit to
standby mode and turning it on, consult the
dealer.
• The disc is dirty. (
>
10) The unit cannot play.
• The lens cleaner has finished cleaning.
Press [
<
OPEN/CLOSE] on the main unit to
eject the disc.
• Displayed when the unit is started and is
switched to standby mode.
• There was a power failure or the AC plug was
disconnected while the unit was on. The unit is
carrying out its recovery process. Wait until the
message disappears.
There are already 32 timer programmes. Delete
unnecessary timer programmes. (
>
34)
The USB device is drawing too much power.
Remove the USB device.
Update of the software (firmware) is started.
You cannot operate the unit until the update is
complete. (
>
84)
Software (firmware) is downloading.
Download will stop when the unit is turned on, or
the timer recording starts. (
>
84)
The media is not supported.
The software (firmware) is being updated.
You cannot operate the unit until the update is
complete. (
>
84)
Messages on the unit’s display
SET
(“
∑
” stands for a number.)
CONV
GUIDE
HARD ERR
NoREAD
PLEASE WAIT
PROG FULL
REMOVE
START
SW-DL
UNSUPPORT
UPD
/
(“
∑
” stands for a number.)
DMR-PWT635EB_eng.book 93 ページ 2014年1月28日 火曜日 午後5時46分