VQT1W65
98
Others
• The picture can become whitish if there is dirt e.g. fingerprints on the lens.
>
If the lens is dirty, turn on the camera, eject the lens barrel (P11) and gently wipe the lens
surface with a soft dry cloth.
• Was this picture taken with the flash at the close range when the zoom was near [W] (1
k
)?
>
Zoom in a little, and then take the pictures. (P32)
• Is this a picture taken in [PIN HOLE] in Scene mode?
>
Check that the exposure is correctly compensated. (P43)
>
Set Auto bracket (P44), [HI-SPEED BURST] (P51), [FLASH BURST] (P51) in Scene mode
or [BURST] (P65) of the [REC] mode menu to [OFF].
• The focus range varies depending on the Recording mode.
>
Set to the proper mode for the distance to the subject.
• The subject is beyond the focus range of the camera. (P30)
• There is camera shake (jitter) or the subject is moving slightly. (P31)
>
The shutter speed becomes slower when pictures are taken in dark places so hold the
camera firmly with both hands to take the pictures. (P27)
>
When taking pictures at a slow shutter speed, use the self-timer. (P42)
• Is the number of recordable pictures 2 or less?
• Is the ISO sensitivity high or the shutter speed slow?
(ISO sensitivity is set to [AUTO] when the camera is shipped. Therefore, when taking pictures
indoors etc. noise will appear.)
>
Decrease the ISO sensitivity. (P61)
>
Set [COLOR MODE] to [NATURAL]. (P66)
>
Take pictures in bright places.
• Has [HIGH SENS.] or [HI-SPEED BURST] in the Scene mode been set? If so, the resolution of
the recorded picture decreases slightly because of high sensitivity processing, but this is not a
malfunction.
• If recording under fluorescent light, the brightness or the hue may change slightly when the
shutter speed becomes fast. This occurs due to the characteristics of fluorescent light. It is not
a malfunction.
The recorded picture is whitish.
The area around where the pictures were taken becomes dark.
The recorded picture is too bright or dark.
2 or 3 pictures are taken at one time.
The subject is not focused properly.
The recorded picture is blurred. The Optical image stabilizer is not effective.
Taking pictures using Auto bracket is not possible.
The recorded picture looks rough. Noise appears on the picture.
The brightness or the hue of the recorded picture is different from the actual
scene.
DMC-FS25PPC-VQT1W65_eng.book 98 ページ ２００９年１月２２日 木曜日 午前１１時６分
