13
VQT1X57
Preparation
∫
When the [CHARGE] indicator flashes
•
The battery temperature is excessively high or low. The charging time will be longer than
normal. Also, charging may not be completed.
•
The terminals of the charger or the battery are dirty. In this case, wipe them with a dry cloth.
Note
•
After charging is completed, be sure to disconnect the power supply device from the electrical
outlet.
•
The battery becomes warm after using it and during and after charging. The camera also
becomes warm during use. This is not a malfunction.
•
The battery will be exhausted if left for a long period of time after being charged.
•
The battery can be recharged even when it still has some charge left, but it is not
recommended that the battery charge be frequently topped up while the battery is fully
charged. (The battery has characteristics that will reduce its operating duration and cause the
battery to swell up.)
•
When the operating time of the camera becomes extremely short even after properly charging
the battery, the life of the battery may have expired. Buy a new battery.
•
Do not leave any metal items (such as clips) near the contact areas of the power plug.
Otherwise, a fire and/or electric shocks may be caused by short-circuiting or the
resulting heat generated.
∫
Battery indication
The battery indication is displayed on the LCD monitor.
[It does not appear when you use the camera with the AC adaptor (DMW-AC5PP;
optional) connected.]
•
The indication turns red and blinks if the remaining battery power is exhausted. (The status
indicator blinks when the LCD monitor turns off.) Recharge the battery or replace it with a fully
charged battery.
∫
The battery life
Recording conditions by CIPA standard
•
CIPA is an abbreviation of [Camera & Imaging Products Association].
•
Temperature: 23
o
C (73.4
o
F)/Humidity: 50% when LCD monitor is on.
¢
•
Using a Panasonic SD Memory Card (32 MB).
•
Using the supplied battery.
•
Starting recording 30 seconds after the camera is turned on. (When the Optical image stabilizer
function is set to [AUTO].)
•
Recording once every 30 seconds
with full flash every second recording.
•
Rotating the zoom lever from Tele to Wide or vice versa in every recording.
•
Turning the camera off every 10 recordings and leaving it until the temperature of the battery
decreases.
¢
The number of recordable pictures decreases in Auto Power LCD mode and Power LCD
mode.
(P23)
The number of recordable pictures varies depending on the recording interval time.
If the recording interval time becomes longer, the number of recordable pictures
decreases. [e.g. When recording once every 2 minutes, the number of recordable
pictures decreases to about 87.]
About the Battery
(charging/number of recordable pictures)
Number of recordable
pictures
Approx. 350 pictures
By CIPA standard in Normal picture
mode
Recording time
Approx. 175 min
DMC-FX48P_PC~VQT1X57_eng.book 13 ページ ２００８年１２月２６日 金曜日 午後６時２５分
