193
VQT2S42
Others
[MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE
WRITING SPEED OF THE CARD]
• Use a card with SD Speed Class
¢
with “Class 4” or higher when recording motion pictures in
[AVCHD Lite].
Also, use a card with SD Speed Class with “Class 6” or higher when recording motion pictures
in [MOTION JPEG].
¢
SD Speed Class is the speed standard regarding continuous writing.
• In the event that it stops even after using a “Class 4” card or higher, the data writing speed has
deteriorated so it is recommended to make a backup and then format (P40).
• Depending on the type of the card, motion picture recording may stop in the middle.
[THIS CARD IS NOT FORMATTED WITH THIS CAMERA, AND NOT SUITABLE FOR
MOVIE RECORDING.]
• The writing speed is lower if the card has been formatted using a PC or other equipment. As a
consequence, motion picture recording may stop in the middle. If this happens, make a
backup of the data and format (P40) the card in this unit.
[A FOLDER CANNOT BE CREATED]
• A folder cannot be created because there are no remaining folder numbers that can be used.
(P174)
>
Format the card after saving necessary data on a PC etc. (P40) If you execute
[NO.RESET] in the [SETUP] menu after formatting, the folder number is reset to 100.
(P40)
[PICTURE IS DISPLAYED FOR 16:9 TV]/[PICTURE IS DISPLAYED FOR 4:3 TV]
• The AV cable is connected to the camera.
>
Press [MENU/SET] if you want to delete this message at once.
>
Select [TV ASPECT] in the [SETUP] menu if you want to change the TV aspect. (P38)
• This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (P173,
175)
[NO BATTERY POWER REMAINS]
• The remaining battery power is low.
>
Charge the battery.
[THIS BATTERY CANNOT BE USED]
• The battery cannot be recognised by the camera.
>
Use a genuine Panasonic battery. If this message is displayed even when a genuine
Panasonic battery is used, contact the dealer or your nearest Service Centre.
• The battery cannot be recognised as its terminal is dirty.
>
Remove any dirt etc. from the terminal.
[PLEASE MAKE SURE TO TURN ON THE POWER OF EXTERNAL MICROPHONE.]
• When attaching the stereo microphone (DMW-MS1; optional), check the battery status and
make sure the power is on before use. (P182)
DMC-G2K&G2W&G2EB-VQT2S42_eng.book 193 ページ 2010年4月13日 火曜日 午後7時40分