Referen
ce
35
VQT3V20
U59
¾
The unit is hot.
The unit switches to standby for safety
reasons. Wait for about 30 minutes until the
message disappears.
Select a position with good ventilation when
installing the unit.
H
or F
(“
” stands for a number.)
¾
There is something unusual.
¾
Check the unit using the troubleshooting
guide. If the service number remains
displayed, do the following.
1
Disconnect the plug from the AC outlet, wait a
few seconds, then reconnect it.
2
Press [
Í
/I] to turn the power on.
If the service number remains displayed despite
doing the above, request service from the dealer.
Inform the dealer of the service number when
requesting service.
START
¾
The system is being restarted during the
firmware update. Please do not turn off the
unit.
UPD
/
(“
” stands for a number.)
¾
The firmware is being updated.
Please do not turn off the unit.
FINISH
¾
The firmware update is complete.
DMP-BDT220_VQT3V20_eng.book 35 ページ 2011年12月5日 月曜日 午後5時35分