Other fu
nctions
TQBS0024
80
Software (Firmware)
Update
Software of this unit can be updated automatically
by the following methods at the specified time.
• From Internet
Network connection and setting are required.
(
>
15, 18)
If a software (firmware) update is available, a
notification is displayed.
Update of the software (firmware) will start when
the unit is turned to standby mode.
• It may take up to a few hours until the update is completed
depending on the network environment.
• The timer recording always takes preference over the
software (firmware) download; if the timer recording is
scheduled to start, the downloading will be performed at the
next opportunity.
• You can also download the latest software (firmware) from
the following website.
http://panasonic.jp/support/global/cs/
Software (firmware) of CAM (compatible CI Plus)
can be updated automatically from broadcasts.
Availability of software (firmware) update is
detected while viewing the programmes that are
compatible with CI Plus.
2
Follow the instructions on the screen.
• Operations such as view, playback, or record cannot be
performed while upgrading the CAM.
Any buttons on the remote control or the unit cannot be
used while upgrading the CAM.
• If the timer recording is started, CAM software upgrade is
cancelled to start recording.
• For details, refer to your CAM’s operating instructions or
consult your dealer.
You cannot operate the unit until the update
is complete. Don’t remove the AC mains lead
during the update. Removing the AC mains
lead while the update is in progress may
damage the unit.
Update software (firmware) of this unit
• From broadcasts
(Default setting is 3 a.m.
>
96, Software
Update in Standby)
•
[BCT765]
[BCT760]
[DVB-C]
The CATV terminal connection is not
applicable to this function.
To update the software (firmware)
immediately
Use the “Software Update Now ( Broadcast )”
function or “Software Update Now ( Internet )”
function. (
>
96)
•
[BCT765]
[BCT760]
[DVB-C]
Some cable providers do not support
this function.
New software version has been found.
The software will be updated automatically
after this unit is switched to standby.
Do not disconnect the AC mains lead.
CI Plus compatible CAM software
(firmware) update
1
When notification is displayed on the screen,
select “Yes” and press [OK].
• If for some reason the notification is not
displayed, or if cancelled, the notification is
instead displayed on the channel
information (
>
26).
e.g.,
To execute CAM software upgrade, press
the red button.
10:30
Now
Change category
All DVB Channels
NEWS
9:00 - 11:00
CAM Upgrade Info
DMR-BST&BCT765&760EG_eng.book 80 ページ 2017年3月2日 木曜日 午後6時35分