Reference
TQBS0024
98
Screen size is wrong.
• Adjust the aspect ratio setting on TV.
• Check “Aspect for Recording” before recording
or picture quality change. (
>
89)
[BCT765]
[BCT760]
TV reception is not displayed.
• Broadcast signals are not output from this unit’s
RF OUT terminal. Select “On” in “RF OUT
( CATV Signal )” or “RF OUT ( Aerial Signal )”.
(
>
95)
The black screen appears on the TV.
• This phenomenon may occur, depending on the
TV setting, when “Quick Start” is activated.
Depending on the TV, this phenomenon may be
prevented by reconnecting to a different HDMI
input terminal.
The screen changes automatically.
• If “Screen Saver” is set to “On”, the screen saver
function will be activated when there is no
operation for 5 minutes or more. (
>
91)
There is a lot of image lag when playing video.
• Set to “0” all items in the “Noise Reduction”.
(
>
53)
• Set “Audio Delay”. (
>
91)
• The unit’s TV System is different from that of the
disc. Change the TV System. (
>
91, TV
System)
• The picture may be distorted or a black screen
may appear between scenes recorded with
different aspect ratios.
• Set “Deep Colour Output” (
>
92) or “Contents
Type Flag” (
>
92) to “Off”.
[BCT765]
[BCT760]
•
[DVB-T]
(Germany only) Check the broadcast
system. This unit does not support DVB-T2.
3D video is not output correctly.
• 3D video may be output correctly by changing
the following settings:
- “Signal Format” (
>
50, 3D settings during
playback)
• Check the settings of the connected TV.
• When a non-3D compatible amplifier/receiver is
connected between this unit and a TV, 3D video
is not output. (
>
13)
• When “Audio Output” is set to “Off”, 3D video
may not be output correctly. (
>
92)
TV screen and video
The images do not appear on the TV.
The picture is distorted during play, or video
is not played correctly.
• Check the connections. (
>
11, 12)
• Check the settings of the connected TV, etc.
• An incorrect resolution is selected in “Video
Format”. (
>
91) Reset the setting as follows:
1 While the unit is on, press and hold [OK], the
yellow button and the blue button at the
same time for more than 5 seconds.
• “00 RET” is displayed on the front panel
display.
2 Repeatedly press [
1
] (right) until “04 PRG”
is displayed on the front panel display.
3 Press and hold [OK] for at least 3 seconds.
Set the item again.
• When Dolby Digital Plus, Dolby TrueHD,
and DTS-HD
®
audio are not output
properly, select “Yes” in “Default Settings”
and make proper settings. (
>
96)
DMR-BST&BCT765&760EG_eng.book 98 ページ ２０１７年３月２日 木曜日 午後６時３５分
