Co
nveni
e
nt
f
unct
ions
VQT3C14
80
Changing the unit’s settings
∫
Manual Tuning
You can set each channel manually.
1
Select the channel.
2
Adjust the frequency.
≥
Adjust the frequency by checking the signal strength
and signal quality displays.
3
Press [OK] to start scan.
The set channel is displayed in the table.
∫
Update Channel List
You can update channels to the latest one.
≥
This takes about 3 minutes.
“Finished” is displayed when the search is finished.
Press [RETURN
].
∫
Child Lock ( Parental Rating )
You can restrict the viewing and recording of channels
unsuitable to children.
Set a ratings level to limit broadcast viewing and playback.
≥
Follow the on-screen instructions.
≥
PIN is required to change. (
>
78)
∫
Signal Condition
You can check the quality and strength of signals.
Press [CH
W X
] to select the channel.
Signal Quality
Signal Strength
≥
When the signal is too strong (red bar), reduce the signal
amplification at your aerial.
∫
New Channel Message
Set whether to obtain the information automatically when a
new digital channel is added.
≥
After performing “Update Channel List” or “Manual Tuning” if the channel
number has already been assigned, channel number for the newly tuned
channel will be assigned from 800ch onward.
Digital TV Manual Tuning
Physical Channel
No.
New
Channel Name
Type
0
10
0
10
[ ]
Signal Quality
Signal Strength
RETURN
Select offset
Select physical channel
Start tuning
MHz
Digital TV:0
Scan
CH 6
69
RF Ch
Digital TV:0
Searching
Quality
Type
Channel Name
RETURN
This will take about 3 minutes.
Digital TV Update Channel List
Red bar
The signal quality is bad.
Yellow bar
The signal quality is poor.
Green bar
The signal quality is good.
0
Signal strength is 0%.
10
Signal strength is 100%.
Channel Name
Digital TV Signal Condition
RETURN
Channel Up
Good
Poor
Bad
Channel Down
Signal Strength
Signal Quality
RF Parameter
[ ] MHz
Network Name
0
10
8
6
4
2
DMRBWT800&700GL_eng.book 80 ページ ２０１１年２月１４日 月曜日 午後３時５０分
