10
RQT7540
Ge
tti
ng s
ta
rte
d
STEP
1
Connection
≥
Decoder here means the device used to decode scrambled broadcasts (Pay TV).
≥
Change the “AV2 Input” and “AV2 Connection” settings in the SETUP menu to match the connected equipment (
page 41) after tuning is
completed (
∫
To enjoy multi-channel surround sound on
DVD-Video
Connect an amplifier with Dolby Digital, DTS and MPEG decoders
using an optical digital audio cable and change the settings in
“Digital Audio Output” (
≥
You cannot use DTS Digital Surround decoders not suited to
DVD.
≥
Even if using this connection, output will be only 2 channels when
playing DVD-Audio.
∫
Connection to a stereo amplifier
Connecting a decoder or digital receiver
P
R
RF IN
RF OUT
COMPONENT
VIDEO OUT
(NTSC:480P/480I,
PAL:576P/576I)
P
B
Y
AV1 (TV)
AV2 (DECODER/EXT)
AV OUT
21-pin Scart lead
This unit’s
rear panel
Decoder or digital receiver’s
rear panel
Connecting an amplifier or system component
R - AUDIO -
R - AUDIO -
OPTICAL
DIGITAL AUDIO OUT
(PCM/BITSTREAM)
AC IN
OPTICAL IN
Optical digital audio cable
Do not bend this cable sharply.
Insert fully, with this side facing up.
This unit’s rear panel
Amplifier’s rear panel
R - AUDIO - L
VIDEO S-VIDEO
R - AUDIO - L
VIDEO S-VIDEO
OPTICAL
OUT
AV
4
I
N
DIGITAL AUDIO OUT
(PCM/BITSTREAM)
AUDIO IN
R L
Audio cable
Red White
Red White
This unit’s rear panel
Amplifier’s rear panel
Do not place the unit on
amplifiers or equipment
that may become hot.
The heat can damage the unit.
7540en.book 10 ページ 2004年2月10日 火曜日 午後12時58分