78
VQT2J12
Troubleshooting guide
Cannot operate the television.
The remote control doesn’t work.
¾
Change the manufacturer code. Some televisions cannot be
operated even if you change the code. (
>
70)
¾
The remote control and main unit are
using different codes. Change the code
on the remote control. (
>
68)
Press and hold [OK] and the indicated
number button at the same time for more than 5 seconds.
¾
The batteries are depleted. Replace them with new ones. (
>
4)
¾
You are not pointing the remote control at the main unit’s
remote control signal sensor during operation. (
>
4)
¾
Coloured glass may obstruct the signal reception/transmission.
¾
Don’t place the signal sensor in direct sunlight or in areas that
may be subject to sunlight exposure.
¾
It may be necessary to set the code on the remote control again
after changing the batteries. (
>
68)
¾
It may be necessary to set the manufacturer code again after
changing the batteries. (
>
70)
¾
The child lock function is activated. (
>
70)
The unit is on but cannot be operated.
¾
Recording drive or playback drive has not been selected
properly. (
>
19, 20)
¾
Some operations may be prohibited by the disc.
¾
The unit is hot (“U59” appears on the display). Wait for “U59” to
disappear.
¾
One of the unit’s safety devices may have been activated.
Reset the unit as follows:
1
Press [
Í
/I] on the main unit to switch the unit to standby.
If the unit doesn’t switch to standby, press and hold [
Í
/I] on
the main unit for about 3 seconds. The unit is forcibly
switched to standby.
Alternatively, disconnect the AC mains lead, wait one
minute, then reconnect it.
2
Press [
Í
/I] on the main unit to switch it on. If the unit still
cannot be operated, consult the dealer.
Cannot eject disc.
¾
The unit is recording.
¾
Linked timer recordings with external equipment is in recording
standby (“EXT-L” on the unit’s display blinks when [
Í
] is
pressed). Press [EXT LINK] to cancel the recording standby.
(
>
26)
¾
The unit may have a problem. While the unit is off, press and
hold [
∫
] and [CH
W
]
on the main unit at the same time for about
5 seconds. Remove the disc and consult the dealer.
If the Child Lock function is activated, above operation does not
work. Cancel the Child Lock function. (
>
70)
Cannot tune channels.
Cannot download channel presets from the
television.
¾
Check the connections. (
>
8, 71)
¾
You must connect to a television equipped with the Q Link
function with a fully wired 21-pin Scart cable/
V
IERA Link
(
HDAVI Control 3
or later) function
w
ith an HDMI cable
to
download channel presets.
Startup is slow.
¾
Deactivate “Power Save in Standby” in the Setup menu. (
>
69)
¾
Startup takes time in the following situations:
– A disc other than a DVD-RAM is inserted.
– The clock is not set.
– Immediately after a power failure or the AC mains lead is
connected.
– For a few minutes after 5:15 am due to system maintenance
of this unit.
– When the unit is connected with an HDMI cable.
Operation
DMR-EH6353EC-VQT2J12_eng.book 78 ページ ２０１０年１月２０日 水曜日 午前１１時４５分
