* Note 3:
Please prepare latest firmware updating disc.
*Main Firm is being recorded in HDD, but new HDD has no data.
CAUTION:
·
Writing of Main Firm needs 3, 4 minutes.
·
Never cut the power of DVD Recorder until writing in Firmware ends.
·
Initial settings and contents of reservation will not change if writing is normally completed.
Writing Procedure of Main Film:
1. Prepare updating disc for firm ware
2. Replace HDD
3. Turn on power of DVD Recorder
4. After [PLEASE WAIT] is displayed on FL., [HDD ERR] is displayed on FL
5. Tray opens automatically
6. Insert updating disc for Firmware and press OPEN / CLOSE key
(If a wrong disc was insered, [NG DISK] [NO FVU] is displayed on FL.)
7. [LOAD]
→
[LD FVU]
←→
[M_FIRM] are displayed on FL alternately
8. [MAIN]
←→
[UPD OK] blink alternately and Tray opens. Take out disc (Writing was finished)
9. Press Power button to turn off power
10. Press Power button to turn on power
11. [HELLO]
→
[SELF CHECK] are displayed on FL
12. [UNFORMATED] is displayed on FL
13. After [UNFORMAT] was displayed, message to request FORMAT is displayed on TV screen
14. Select [Yes] and press [ENTER] key to format HDD
(After FORMAT, program in HDD will be lost, but Main firm will not be lost
“Write of the main farm” is completed above
* Drive firm is not updated by above operation. If you wish update Drive firm, please prepare the disc for latest firmware update,
and write again.
* If the version of the firm you have prepared was same as or later than has already been written in deck, “UNSUPPORT” is
displayed on FL.
* In a usual updating of firmware, writing is not performed when the timer reservation standby was not released.
11.2.2. NOTICE AFTER REPLACING RAM/DIGITAL P.C.B. MODULE
After replacing RAM/Digital P.C.B. Module, “TM AV1” is displayed on FL. Once power off, and start-up again.
42
DMR-EX75EG / DMR-EX75EC / DMR-EX75EB / DMR-EX85EG / DMR-EX85EB