Error Code
Diagnosis contents
Description
Monitor Display
Automatic FL display
F09
Serial
Communication
Error
between VHS Microprocessor
and Timer Microprocessor.
Please
confirm
Serial
Communication
terminal of Microprocessor.
NOTE:
If F09 appears just after updating Firmware,
pull off and insert AC plug, then it will
disappear.
No display
F34
Initialization error when main
microprocessor is started up
for program recording
When initialization error is detected after
starting up main microprocessor for program
recording,
the
power
is
turned
off
automatically.
The event is saved in memory.
No display
No display
F58
Drive hardware error
When drive unit error is detected, the event is
saved in memory.
No display
No display
F60
DVD module has not been
started.
Defect of Digital P.C.B.
Mode: No change
No display
HDMI
HDMI connection check
This unit is confirming that ut is connected
with
equipment
compatible
with
HDAVI
control.
No display
F74
HDIM
Device
Key
Communication error.
HDMI connection could not be authenticated
due to a transfer malfunction.
Factor of HDMI Device key-road failure
·
When HDMI LSI is damaged.
·
When the bus line of I2C doesn´t operate
normally.
·
When device key information recorded is
damaged.
No display
F75
HDIM Device Key Information
error
HDMI connection could not be authenticated
due to an internal data malfunction.
Factor of HDMI Device key-road failure
·
When HDMI LSI is damaged.
·
When the bus line of I2C doesn´t operate
normally.
·
When device key information recorded is
damaged.
No display
UNSUPPO
RT
Unsupported disc error
*An unsupported format disc was played,
although the drive starts normally.
*The data format is not supported, although
the media type is supported.
*Exceptionally in case of the disc is dirty.
“This
disc
is
incompatible.”
Display for 5 seconds.
NO READ Disc read error
*A disc is flawed or dirty.
*A poor quality failed to start.
*The track information could not be read.
“Cannot
read.
Please check the
disc.”
HARD
ERR
Drive error
The drive detected a hard error.
“
DVD drive
error.”
Display for 5 seconds.
No REC
Recording is impossible
[No REC] is displayed when recording is
impossible due to the defect, dirt or wound of
media.
No display
SELF
CHECK
Restoration operation
Since the power cord fell out during a power
failure or operation, it is under restoration
operation.
*It
will
OK,
if
a
display
disappears
automatically. If a display does not disappear,
there is the possibility that defective Digital
P.C.B.
No display
“0” is displayed one by one.
17
DMR-EZ47VP / DMR-EZ475VP
Summary of Contents for DMR--EZ475VP
