Troubleshooting
VQT5C33
97
The software (firmware) is being updated.
You cannot operate the unit until the update is
complete. (
>
86)
The unit is hot.
The unit switches to standby for safety reasons.
Wait for about 30 minutes until the message
disappears.
Install or place this unit with good ventilation.
A malfunction has occurred. The unit is trying to
restore to the normal operation. Once the
message disappears you can use the unit again.
If it remains displayed, consult the dealer.
HDMI cannot be output because it is connected to
a model that does not support copyright
protection.
The unit fails to operate properly. Press [
Í
/I] on
the main unit to switch the unit to standby mode.
Now press [
Í
/I] on the main unit again to turn the
unit on.
The HOLD function is activated. (
>
88)
There is something unusual. (The service number
displayed after H and F depends on the unit’s
condition.)
Reset the unit as follows:
1 Disconnect the plug from the household mains
socket, wait a few seconds, then reconnect it.
2 Press [
Í
/I] to turn the power on. (The unit may
be fixed.)
Request service from the dealer. Inform the
dealer of the service number when requesting
service.
UPD
/
(“
∑
” stands for a number.)
U59
U61
U76
U99
X HOLD
H
or F
(“
∑
” stands for a number.)
DMR-HCT230_130EG_eng.book 97 ページ 2013年7月8日 月曜日 午後5時42分