Troubleshooting
VQT4G61
84
Troubleshooting guide
The USB device is drawing too much power.
Remove the USB device.
Update of the software (firmware) is started.
You cannot operate the unit until the update is
complete. (
>
76)
Software (firmware) is downloading.
Download will stop when the unit is turned on, or
the timer recording starts. (
>
76)
The media is not supported.
The software (firmware) is being updated.
You cannot operate the unit until the update is
complete. (
>
76)
The unit is hot.
The unit switches to standby for safety reasons.
Wait for about 30 minutes until the message
disappears.
Do not block the cooling fan on the rear of the
unit.
A malfunction has occurred. The unit is trying to
restore to the normal operation. Once the
message disappears you can use the unit again.
If it remains displayed, consult the dealer.
HDMI cannot be output because it is connected to
a model that does not support copyright
protection.
The unit fails to operate properly. Press [
Í
/I] on
the main unit to switch the unit to standby mode.
Now press [
Í
/I] on the main unit again to turn the
unit on.
The HOLD function is activated. (
>
77)
There is something unusual. (The service number
displayed after H and F depends on the unit’s
condition.)
Reset the unit as follows:
1 Disconnect the plug from the household mains
socket, wait a few seconds, then reconnect it.
2 Press [
Í
/I] to turn the power on. (The unit may
be fixed.)
Request service from the dealer. Inform the
dealer of the service number when requesting
service.
REMOVE
START
SW-DL
UNSUPPORT
UPD
/
(“
∑
” stands for a number.)
U59
U61
U76
U99
X HOLD
H
or F
(“
∑
” stands for a number.)
DMRHW220GL_eng.book 84 ページ 2012年4月27日 金曜日 午後2時12分