Setup
TQBS0033
95
Digital Audio Output
PCM Down Conversion
Check the sampling frequencies supported
by the coaxial input of the connected device.
If the device does not support certain
sampling frequencies, set the appropriate
frequency setting.
• On ( 48 kHz ):
The maximum sampling frequency of
signals is limited to 48 kHz.
(Choose if the connected device does not
support signals with a sampling frequency
of 96 kHz or 192 kHz.)
• On ( 96 kHz ):
The maximum sampling frequency of
signals is limited to 96 kHz.
(Choose if the connected device does not
support signals with a sampling frequency
of 192 kHz.)
• Off:
Signals are output as 192 kHz.
Dolby D / Dolby D + / Dolby TrueHD
DTS / DTS-HD
MPEG
HE-AAC
Select the audio signal to output.
• Select “PCM” when the connected
equipment cannot decode the respective
audio format.
• Not making the proper settings may result in
noise.
System Volume Adjustment
If the volume of a programme being watched
through this unit is different than the volume
of a programme being watched directly on the
TV, the gap may be reduced by switching this
setting to Mode 1 or Mode 2. (This function
works only while you are watching a
programme or playing back a programme
recorded in DR mode with this unit.)
BD-Video Secondary Audio
Turn on/off the clicking sound on the menu
and audio with secondary video.
• To enjoy BD-Video that supports Dolby Atmos
R
or
DTS:X
TM
Connect this unit to an AV amplifier or similar device that
supports it with an HDMI cable, and select the following
settings:
- Dolby D / Dolby D + / Dolby TrueHD: “Bitstream”
- DTS / DTS-HD: “Bitstream”
- BD-Video Secondary Audio: “Off”
Dolby Atmos is a trademark of Dolby Laboratories.
HDMI Output Settings of Music Playback
Select the HDMI output settings.
• If “Sound Quality Priority” is selected, the audio
noise is minimised during music playback by
automatically switching the video output to
1080i.
Settings for High Clarity Sound
This function is effective when “High Clarity
Sound” (
>
59) is set to “On (Video Off)” or “On
(Video On)”.
Audio Output
Select the terminal from which you want to
output audio signals. (
>
14 - 18)
• Set an option for video playback and audio
playback.
Front Panel Display
Select whether or not to turn on/off the front
panel display.
• Set an option for video playback and audio
playback.
Audio Delay
Mis-sync between the video and audio is
corrected by delaying the audio output.
Audio for HG / HX / HE / HL / HM Recording
If the programme has multi channel audio
(5.1 ch or 2 ch), priority is given to what you
select.
• This setting will give effect in the following
cases.
- Timer recording (
>
39)
- Picture Quality Change (
>
61)
- Copy (Picture Quality Change) in HG, HX,
HE, HL or HM mode from a programme
recorded in DR mode. (
>
66, 68)
DMR-UBC&UBS90EG_eng.book 95 ページ ２０１７年３月２日 木曜日 午後７時６分
