Gettin
g started
TQBS0033
22
When selecting “Single Cable System” in
Step 6.
1 Select the “Single Cable Version”.
• Select the setting that matches the version of
your equipment.
• Check the Single Cable Version setting in
advance.
2 Make the settings of user band.
• User Band
You can set C1 to C8. (If you have selected
“Single Cable 2.0 (JESS)”, a value from C1
to C32 can be set.) Set to a User Band not
used by any other device.
• When only one User Band of the Router is
assigned, set “Tuner 2” and “Tuner 3” to
“OFF”.
Note that you will not be able to record two
programmes simultaneously.
When two User Bands of the Router are
assigned, set “Tuner 3” to “OFF”.
Note that you will not be able to record
three programmes simultaneously.
• User Band Frequency
Set the User Band Frequency with number
buttons.
• User Band PIN
If the single cable router requires a PIN to
access an user band, enter the PIN.
• For details, read the manual of the single
cable router, etc.
3 Select “Start Auto Setup”, then press [OK].
• Set User Band as required.
• Refer to the operating instructions for your single cable
router for information about each item.
After completing “Easy Setting”, you can continue
with “Easy Network Setting”.
Follow the on-screen instructions to establish
your connection settings.
Select “Wired” or “Wireless”, then press [OK].
LAN cable connection (“Wired”)
Follow the on-screen instructions to apply your
connection settings.
Wireless LAN connection (“Wireless”)
Before beginning wireless connection setup
• Obtain your network name (SSID
§
1
).
• If your wireless connection is encrypted, please
be sure that you know your encryption key.
• The default SSID
§
1
, Password (Key) etc., may
be printed on the router.
Confirm
Select
RETURN
Single Cable 2.0 (JESS)
Single Cable
Single Cable Version
Single Cable - EN50494:
Allow up to 8 user bands
Single Cable 2.0 (JESS) - EN50607:
Allow up to 32 user bands
Unicable II
e.g.,
User Band Settings
OK
Select
RETURN
Start Auto Setup
Please confirm user band settings before starting Auto Setup.
Tuner 1
C1
1284 MHz
User Band Frequency
Off
User Band PIN
User Band
Tuner 2
C2
1400 MHz
User Band Frequency
Off
User Band PIN
User Band
Tuner 3
C3
1516 MHz
User Band Frequency
Off
User Band PIN
User Band
Easy Network Setting
OK
RETURN
Easy Network Setting
Select a connection mode.
Wired
Wireless
SSID XXXXXXXXXXXX
KEY XXXXXXXXXXXX
PIN XXXXXXXXX
e.g.,
DMR-UBC&UBS90EG_eng.book 22 ページ ２０１８年５月２８日 月曜日 午後１２時５分
