Setup
TQBS0146
77
HLG / PQ Conversion
Set whether or not to convert HDR (High
Dynamic Range) videos in HLG format to
PQ format before outputting them when
this unit is connected to a TV that supports
only HDR (PQ) format.
• When “HDR (High Dynamic Range)
Output” is set to “Off”, this setting is
disabled.
Audio Output
Select “Off” when connected to an
amplifier/receiver with a DIGITAL AUDIO
OUT terminal.
7.1ch Audio Reformatting
[BD-V]
Surround sound with 6.1 ch or less is
automatically expanded and played back
at 7.1 ch.
• If “Off” is selected, sound is played over
the original number of channels. (Note
that in the case of 6.1 ch audio, playback
will be at 5.1 ch)
Audio reformatting is enabled in the
following cases:
- When you have selected “PCM” in
“Digital Audio Output”. (
>
74)
- When the audio is Dolby Digital, Dolby
Digital Plus, Dolby TrueHD or LPCM.
Contents Type Flag
If “Automatic” is selected, the optimal
method of playback depending on the TV
(e.g. cinema) will automatically be
selected (only when the TV supports
Contents Type Flag).
Network
Easy Network Setting
Press [OK] to start Easy Network Setting. (
>
14)
Network Settings
LAN Connection Mode
Select the LAN connection method.
• When not using wireless LAN (when turning
it off), select “Wired”.
Wireless Settings
This allows to set and check the connection
settings of the Wireless router.
Search for wireless network
WPS (PUSH button)
WPS (PIN code)
Manual setting
Select a connection method to wireless
access point.
IP Address / DNS Settings
Check the connection of the network or set
the IP address and DNS.
• To set the IP address and DNS
1 Set “IP Address Auto-Assignment” and
“DNS-IP Auto-Assignment” to “Off”.
2 Select the item, then press [OK] to show
the respective setting.
• When the router’s DHCP server function is
not activated, check the numbers of other
connected devices such as personal
computers, then assign a number different
from those of other devices for the “IP
Address” and assign the same number for
“Subnet Mask” and “Gateway Address”.
Proxy Server Settings
Check and set the connection to the Proxy
server.
• Press [OK] to show the respective setting.
DMR-UBT1GL_eng.book 77 ページ ２０１７年７月２５日 火曜日 午後１時４５分
