624
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
Fig. 7-003
f. Press SW1 and SW2 simultaneously to store the adjustment value.
(This will lower the Swinging Guide.)
g. Shift all bits of SW3 to OFF, and install the Rear Cover of the Finisher Unit.
3. Adjusting the Staple Position (stapler movement range)
Adjust as follows if you have replaced the Finisher Controller PCB. Performing the steps will affect all
paper sizes and all stapling positions.
a. Remove the Rear Cover from the Finisher Unit.
b. Set SW3 on the Finisher Controller PCB as indicated.
Fig. 7-004
c. If you are using A4 paper, press SW1 on the Finisher Controller PCB. If you are using LTR paper,
press SW2 on the Finisher Controller PCB.
• Pressing SW1 or 2 will open the Swing Guide and cause the feed belt to rotate.
d. Within 5 sec. after pressing the Switch, place one sheet of A4/LTR paper between the Alignment
Plate and the Guide Plate, butting it against the stoppers.
• When the Finisher detects the paper, it will lower the Swing Guide and execute stapling (rear, 1-
position). Take out the stapled paper manually as delivery will not be executed.
Alignment Plate
A4/LTR Paper
Shift by SW2
Shift by SW1
Stopper
Stopper
Guide Plate
1
ON
2
3
4
5
6
7
8
Summary of Contents for DP-3530
