630
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
If this happens:
a. Turn over the paper in the Paper Tray and load the paper again.
If downward curling is larger than before the paper was loaded again, return the paper in the
Paper Tray to its original orientation.
From here on, too, if downward curling is excessive, resulting in output sheets being stacked
incorrectly, try setting the downward curling sheet mode as indicated.
(2) Setting the downward curling sheet mode
a. Turn the Copier OFF.
b. Set SW3 on the Finisher Controller PCB as indicated.
Fig. 7-017
c. Turn the Copier ON.
• When the Machine enters the downward curling sheet mode, the stop position of the Stacking
Tray is raised by about 10mm when stack sheets are output so that output sheets are stacked
without being away from the stacking wall.
• After setting this mode, if sheets with little curling or upward curling sheets are output and
stacked, the stacking tray is raised too far. For this reason, sheets are stacked pressed out by
subsequent output sheets. (Fig. 7-018). Set this mode after carefully checking the type of paper
used by the customer.
Fig. 7-018
1
ON
2
3
4
5
6
7
8
Summary of Contents for DP-3530
