6-3 Configuring the Machine with Tools Mode
156
Custom Presets
6
Then select Close until the screen shown in Step 4 is
displayed.
Select Exit Tools.
The new default screen is defined.
Configuring the Basic Features screen
This feature allows you to select the number of features to be displayed
on the Basic Features screen and which features to be displayed on
these basic buttons.
•
Display 2 Features
Assign the features to the two buttons (Feature Buttons 1 and 2)
•
Display 3 Features
Assign the features to Feature Button 1, Feature Button 2 and Feature
Button 3.
•
Display 4 Features
Assign the features to Feature Button 1, Feature Button 2, Feature
Button 3 and Feature Button 4.
Procedure
Press Settings/Meter Check.
Select Tools Mode.
Basic Features screen can display a
maximum of four feature buttons.
You can select to display two, three
or four features in the layouts shown
below.
The factory default is Display 3
Features.
The screen on the right is when the
Auditron feature is enabled. See
Chapter 9 Using the Auditron
Feature for details.
Summary of Contents for DP-6000
