- 31 -
∫
HDR10+ Setting
You can set enable/disable of the HDR10+
function.
By changing this setting to “On”, you can use the
HDR10+ function under the following conditions:
– A device (TV, etc.) that supports HDR10+ is
connected (
10).
– A disc that supports HDR10+ is played back.
≥
The “Optimum HDR Adjustment” setting is
disabled while using the HDR10+ function.
(
∫
Advanced Settings
Press [OK] to show the following settings:
h
Colour Mode
This setting is for selecting colour-space
conversion of the image signal.
h
Deep Colour Output
Set the output method to be used when this unit
is connected to a TV that supports Deep
Colour.
h
HDR/Colour Gamut Output
Set the output type for HDR (High Dynamic
Range) material.
h
SDR/HDR Conv. (Network Service)
When Network Service content is played back,
this converts SDR (Standard Dynamic Range)
content to HDR signals to minimise the screen
distortion that occurs when the displayed
content changes. (Available for some Network
Service contents only)
h
HLG / PQ Conversion
Set whether or not to convert HDR (High
Dynamic Range) videos in HLG format to PQ
format before outputting them when this unit is
connected to a TV that supports only HDR (PQ)
format.
≥
When “HDR/Colour Gamut Output” is set to
other than “HDR/BT.2020 (Auto)”, this setting
is disabled.
h
HDR Display Type
Set the type of the connected HDR-compatible
display. The operation of “HDR Optimiser” in the
“Picture Settings” is optimised based on this
setting. (
h
HDCP Output Setting
If you connect to a TV that does not support
HDCP2.2 via an amplifier or speaker, some
images may be displayed as black screens. In
that case, select “HDCP1.4 Limit”.
h
Contents Type Flag
Depending on the playback content, the TV will
output adjusting to the optimal method when a
TV that supports this function is connected.
h
Audio Output
This setting selects whether or not to output
audio from HDMI.
≥
To enjoy audio with the HDMI terminal, select
“On”. To enjoy audio with the OPTICAL/
COAXIAL/2ch AUDIO OUT terminal, select
“Off”. Audio will not be output from the HDMI
terminal regardless of the settings for
“HDMI(VIDEO) Output Mode” and
“HDMI(AUDIO) Output Mode”.
h
7.1ch Audio Reformatting
Surround sound with 6.1ch or less is
automatically expanded and played back at
7.1ch.
≥
If “Off” is selected, sound is played over the
original number of channels. (Note that in the
case of 6.1ch audio, playback will be at
5.1ch.)
≥
Audio reformatting is enabled in the following
cases:
– When you have selected “PCM” in “Digital
Audio Output”.
– When the audio is Dolby Digital, Dolby
Digital Plus, Dolby TrueHD or LPCM.
– BD-Video playback
*1
It displays images at the highest resolution available on
your TV.
*2
A high resolution image/display technology of
approximately 4000 (width)
k
2000 (height) pixels.
*3
A progressive image recorded at a rate of 24 frames per
second (motion-picture film). Many BD-Video movie
contents are recorded in 24 frames/second in accordance
with the film materials.
Summary of Contents for DP-UB9004
Page 47: ... 47 Reference ...
