Remove the solder shorts before trying to make the adjustment.
12.4.1.1. Preparations
1. Connect the main P.C.B. to the traverse ass’y with the extension cable.
2. Install the traverse ass’y to the tilt adjustment jig with three screws and three washers.
Caution
Remove the rubber cushion of the traverse ass’y.
3. Install the traverse ass’y to the disc.
Caution
Make sure the disc is installed on the disc motor securely.
4. Disassemble the Main P.C.B., Operation P.C.B., Inverter P.C.B. and LCD panel as shown in figure below.
5. The disc cannot be played back with the disc cover removed. Press and hold down the S5201 and S5202 (Secure with cellulose
tape).
36
DVD-LS83E / DVD-LS83EB / DVD-LS83EE / DVD-LS83EG / DVD-LS835EE / DVD-LS86EB / DVD-LS86EE / DVD-LS86EG