EBL512 G3 V. 3.0.X
- FIRE ALARM SOLUTIONS OPERATING INSTRUCTIONS
98
30.4. SENSOR VALUES (H4/U4)
Information on heat, smoke or multi detector sensor values.
a) Log on to the c.i.e.
b) Navigate to menu U4.
c) Write the technical number for a specific sensor or press
to start as from sensor 000001.
If there are no sensors (analog detectors) when
is pressed, the list view will not open.
d) Scroll in the list with
.
e) To exit the menu press ESC
.
Sensor: 001-01 (technical address 000001)
Momentary: XX.X%/m
Weekly: XX.X%/m
Perf factor: X.XX%/m
Min: XX.X%/m
Algorithm: X-XX
Max: XX.X%/m
Momentary: XX°C
Min: XX°C
Algorithm: XX
Max: XX°C
Sensor: 001-03 (technical address 000002)
Momentary: XX°C
Min: XX°C
Algorithm: XX
Max: XX°C
Sensor: 001-01 (technical address 000001)
Momentary: XX.X%/m
Weekly: XX.X%/m
Perf factor: X.XX%/m
Min: XX.X%/m
Algorithm: Xxxxxx
Max: XX.X%/m
Momentary: XX°C
Min: XX°C
Max: XX°C
Sensor: 001-01 (technical address 000001)
Momentary: XX.X%/m
Weekly: XX.X%/m
Perf factor: X.XX%/m
Min: XX.X%/m
No. of months left: XX
Max: XX.X%/m
Momentary: XX°C
Min/Max: XX/XX°C
Momentary: XXppm
Weekly: XXppm
Sensor: 001-01 (technical address 000001)
Momentary: XX.X%/m
Weekly: XX.X%/m
Perf factor: X.XX%/m
Min: XX.X%/m
Algorithm: Normal
Max: XX.X%/m
Momentary: XX°C
Min: XX°C
Install date: XXXX-XX-XX
Max: XX°C
For an Analog multi detector 4300 / 4400 in NORMAL mode:
For an Analog heat detector 3308 / 3309 in NORMAL mode:
For an Analog multi detector 4400 in Advanced mode:
For an Analog multi detector with CO 4402 in NORMAL mode:
For an Analog multi detector with isolator 4400I in Advanced mode:
