Panasonic Electric Works Nordic AB
MEW01349
Rev: -
Operating Instructions Fire alarm system EBL512 G3, V1.1.x
13
is space for two 27 Ah batteries. Larger batteries (up to 65 Ah) have
to be placed outside the c.i.e.
The batteries and the power supply are connected to the Main board
(5010), which handles the charging of the batteries, etc. See the
EBL512 G3 Planning Instructions, chapter "Power supply" for more
information.
3.2
S/W versions
Due to continual development and improvement, different S/W
versions can be found. When installing a new control unit in a system
with "older" control units, you might have to update the S/W in the
old control units. T
he same S/W version is required in all control
units
.
3.3
Documents
The following documents are available:
Planning instructions MEW01182
Operating Instructions
Drawings
Normally, information found in one of the documents is not found in
another document, i.e. the documents complement each other.
3.4
Applications
The EBL512 G3 system is intended for small, medium and large
installations. The intelligent control units offer the system designer
and end user a technically sophisticated range of facilities and
functions. Programming (PC software WinG3 and TLON Manager)
and commissioning of the control unit / system is very easy.
Start with one control unit and then later when it is required, add more
units. The TLON network makes it possible to install the control units
in one building or in many buildings.
3.5
PC S/W
3.5.1
WinG3
WinG3
is used for programming and commissioning of one or more
control units:
create / download / backup (upload) of site specific data (SSD)
download of software / settings / conventions / configurations /
control unit & system properties / etc.
create / download the user definable text messages (alarm texts)
shown in the display in the C.U. and ext. FBP / Display units.
WinG3 shall have the same (or higher) version number as the EBL512
G3 software version number (e.g.
1.0
.x and
1.0
.x respectively).
Backup require the same version number (in WinG3 and in EBL512
G3). Old SSD files can be opened and saved in a newer (higher)
version of WinG3 and thereafter downloaded.
