EN10
2. Moving the unit and setting it up.
Since the unit is very heavy (approximately 63 k
•
g
), be careful to avoid back injuries. (The unit must be carried by two persons.)
Put the unit down slowly and carefully watch your step.
•
Assembly
Fix with screws
(One screw on front and rear separately)
Screw Fastening Method
Install the elbow component into the body.
Insert the elbow component into 3 points of the body.
Then press it downward.
1
2
Insertion Section
Internal side of
elbow component.
Screw Hole
Screw Hole
Screw Hole
Allen Key
Allen Key
Do not pinch the finger.
※
Insert the clamp screw into the screw hole. After aligning
with the screw hole on the body, press it downward.
Secure the clamp screw on the edge of Allen Key and
then fasten the screw.
1
2
①
②
②
①
②
②
•
Horizontally align with the hollow
and then lock tight.
•
If inserting the screw into the screw
hole improperly, then it may damage
the screw when fastening the screw
with Allen Key.
Lifting the unit to install and setup the unit
•
hold it correctly.
Place the controller and the
power cord on the seat.
Do not hold here.
Doing so may result
in damage or injury.
Placement area
(place a mat, etc.)
Hold the plastic part.
stiff plastic part inside.
Install the unit with the backrest away
from the wall.
Make sure the backrest does not touch the wall.
cm
More than 10
(When the backrest is fully upright)
At least 3 cm
(When the backrest is fully reclined)
Fasten this side first.
※
English