EN12
Setup of the massage lounger
Before use (installation position)
1
Make sure both main body and accessories of the product
are in the packing box
2
Make sure there is enough space for
the tilting of the product.
●
See EN40 for dimensions of the product.
●
Back cushion
●
Remote controller holder
●
Power line
Keep the product 20 cm from the wall.
Approx. 195 cm
Approx. 30 cm
Mat
Product's are in contact with the floor
Installed on the main
body when delivered
●
Do not expose the product to direct sunlight or a high-temperature place (e.g., in front of heating equipment); otherwise its
synthetic leather may fade or harden.
●
Place a mat below the product to avoid floor damage. The mat should cover the product
’
s area in contact with the floor and
the Leg/Foot massage section area in contact with the floor (minimum dimensions: 120 cm
×
80 cm). See the figure.
●
Install the product close to a power socket.
Main unit
Accessories
●
Safety lock key
Remote controller
Summary of Contents for EP-MA32
