27
English
28
English
FITTING AND REMOVING THE BACKREST
CUSHION COVER AND BACK PAD
Removing
Backrest cushion cover
Unfasten the rear zipper and remove the cushion.
Back pad
1 Unfasten the zippers (3 locations).
2 Unfasten the velcro fastener in the bottom section of the seat, and remove the back pad.
2
2
1
1
Fitting
Backrest cushion cover
1 Check the vertical and horizontal orientation of
the cushion.
Side view
Front
Downward
Slight concave
Narrower at end
2 Fold the cushion forwards and insert it into the
zipper opening.
When the cushion is fully
inserted, hold the top corners
of the cover and shake it up
and down a few times.
Front
3 Close the zipper.
4 To ensure the cushion is equally distributed within the cover, pat the front and rear of the
cover a few times.
Back pad
Make sure that the leg/foot massage lock release strap is exposed.
1 Close the zippers located to the sides of the
seat (2 locations).
2 Pull the cover over the corners of the cushion
on the seat, and, while gently pulling forward
on the cover, fasten the velcro fastener located
at the bottom section of the seat.
2
2
1
1
3 Fasten the zipper located at the top section of
the back pad.
4 Push the zipper covers down between the seat
and the armrests.
3
3
4
4
4
4
27-28
2010/01/20 13:28:54
