16
<Usage frequency>
•
Hair removal is not permanent, so it is
recommended to epilate the underarms
about once a week, and the bikini-line
about once every two weeks.
<For beginners/those with sensitive
skin>
•
We also recommend to use SOFT
•
Using the gentle cap for legs/arms with
the skin guard is best for first time use
or for those with sensitive skin.
The gentle cap for legs/arms has a skin
protector for gentle hair removal by
holding the skin down to reduce pain.
<Tips for best results>
•
Massaging with a body puff may help
prevent ingrown hairs.
• Reddening may occur after use. A cool
towel is helpful in case of pain or a rash.
•
If your skin is dry, apply moisturizer
two days after use.
•
Make sure skin is clean before and
after use.
<Best hair length for epilation>
• Trim your hair before first time use or
if you have not removed hair for a long
time. Hair removal is easier and less
painful when the hair is short.
Shaver head
ES-EY90
<DRY shaving>
DRY shaving is recommended. Before
DRY shaving, wipe away moisture and
sweat from the skin.
<WET shaving>
Wet the skin and apply shower gel to the
skin. Always use only shower gel.
1
1
Attach the shaver head [
G
]�
• Confirm the bikini comb [
F
] is
detached.
2
2
Select the mode by pressing
the power switch [
L
]�
Areas not suitable for epilation (Fig� 9)
Do not use the epilator on the inner side of
the upper arms or areas which are prone
to sagging such as elbows or knees.
<DRY epilation>
• DRY epilation is recommended. Before
DRY epilation, wipe away moisture and
sweat from the skin. Next, press the
power switch.
<WET epilation>
•
For WET epilation, always use only
shower gel. Put the shower gel on the
wet discs and turn on the switch to
make lather. (Fig. 10)
Use on sufficiently wet skin. If you notice
that some hair is not removed during
epilation, try switching to DRY epilation.
•
The pressure sensor works and the
LED light may blink depending on the
amount and type of shower gel used.
Adjust the amount of shower gel or add
water to the discs to dilute the foam.
•
Foam forms, making the epilator
slippery so you can move it quickly.
•
The appliance may not operate at an
ambient temperature lower than
approximately 5 °C.
•
Apply the epilator at a 90° angle and
slide it slowly over your skin.
<Epilating legs or arms>
Attach the fast cap or gentle
Slowly move against the flow
of hair. (Fig. 12)
<Epilating underarms or bikini‑line>
ES-EY90/EY80/EY70/EY31:
Attach the small epilation head.
ES-EY30: Attach the sensitive
area cap to the epilation head.
Lightly apply the epilator at a
90° angle and ensure close
contact with your skin.
Do not move the appliance back
and forth while applied to the skin.
Lift it away from the skin and
change the direction, before
moving it.
Stretch the skin with your fingers
to prevent sagging, and slowly
move the appliance against
the grain of the hair. (Fig. 14)
Summary of Contents for ES-EY30A-V503
