5
Before use
This Wet/Dry shaver can be used for
wet shaving with shaving lather or for
dry shaving. You can use this water-
tight shaver in the shower and clean
it in water. Treat yourself to wet lather
shaves for at least three weeks and
notice the difference. Your Panasonic
WET/DRY shaver requires a little
time to get used to because your skin
and beard need about a month to
adjust to any new shaving method.
Parts identification
(see fig. 1)
A
Protective cap
B
Outer foil
C
Foil frame
D
Inner blade
E
Foil frame release button
F
On/Off switch
G
Battery cover
H
Battery cover release dial
I
Cleaning brush
Replacing batteries
Before replacing the batteries, wipe
the shaver free of moisture to pre-
vent the inside from getting wet.
1. Turn the battery cover release dial
and remove the battery cover.
(Turn the dial in the counter clock-
wise direction and match the
mark to the open position.)
(Fig.2A)
ate.) Do not use a new battery
with an old battery.
3. Replace the battery cover with
the dial mark at open. Check for
proper sealing of the water-proof-
ing ring.
4. After replacing the battery cover
to the main unit, turn the dial mark
to close (Fig. 2C).
For a better shave
Put a thin layer of shaving foam on
your face which works as lubricant.
Shaving foam is the most suitable
among many other shaving aids(gel,
soap, cream, etc). Do not put a thick
layer of shaving foam as it may af-
fect shaver’s performance. If the
shaving head is clogged with foam,
simply rinse it under running water.
And slide the On/Off switch upward
to turn the shaver on. Hold the shaver
at a right angle (90
°
) to your skin (see
fig. 3). Start out shaving by applying
gentle pressure to your face. Stretch
your skin with your free hand and
move the shaver back and forth in
the direction of your beard. You may
gently increase the amount of pres-
sure as your skin becomes accus-
tomed to this shaver. Applying exces-
sive pressure does not provide a
closer shave.
2. Insert the two AA (LR6) alkaline
batteries as shown in the figure.
After checking that their polarity
matches that indicated behind the
shaver mainbody (Fig. 2B). (If the
(+) and (–) poles are not inserted
properly, the motor will not oper-
Cleaning your shaver
(see fig. 4)
For cleanliness and convenience, we
recommend that you clean your
shaver with water and some liquid
hand soap. Regular cleaning will
keep your shaver in good condition
while preventing odors or bacteria
from developing, and maintain the
cutting performance.
With the outer foil in place, apply
some hand soap onto the outer foil.
P05-29.ES3830(欧州) 04.1.26 23:24 ページ 5
